Electronics Forum | Mon Nov 11 10:51:40 EST 2013 | dyoungquist
Are you using lead or lead-free solder? 260C would be good for lead solder but may be a bit low for lead-free. We run our lead-free selective solder pot at 300C although we do not have any pre-heat or top heat, just hot nitrogen blowing around the
Electronics Forum | Fri Nov 08 10:06:24 EST 2013 | zrunkle_api
I have a small resistor pack that I need to place(EXB-N8V510JX). It has Concave terminals not sure how with any of our equipment how to make a terminal with a half circle cut into it. Any help would be great.
Electronics Forum | Sun Nov 10 09:58:38 EST 2013 | kumuda
We have been using a circuit board in the assembly of HV Tank used in X-ray generator. This board acts as a sealant to the oil tank opening. The top side area of the board which comes in contact with oil is conformal coated to avoid oil leak. However
Electronics Forum | Wed Nov 13 15:33:08 EST 2013 | mondalaci
Good question :) I'd say with a machine that is available for an average pick and place operator nowadays. Our manufacturer is not fixed yet, that's why I don't have any specific. On a related note I'm wondering whether the machine is so importan
Electronics Forum | Fri Jan 31 12:22:14 EST 2014 | dandin87
Thanks all, I got it working. And I also actually bought a hard drive with SigPro from Keith, or at least from sigmaprint. The actual problem I think was that we had a newer meteor card, and so the 6.32 install did not have a dll file it required. Fo
Electronics Forum | Wed Nov 27 11:22:06 EST 2013 | mchawg
It's really a dirt simple machine and the one program works for about anything. Been speaking to Larry Sirois at USI through this whole adventure and he has been helpful to the point where I think I have overtaxed his resources. Only so much you can
Electronics Forum | Wed Dec 04 11:39:38 EST 2013 | markhoch
I'm investigating replacing my Stencil Cleaner. After searching the fine archives of SMTNET, I'm as clouded as ever..... So let me ask this... Are there any USERS out there who have a stencil washer that they use every day, and are satisfied with?
Electronics Forum | Wed Dec 04 13:58:55 EST 2013 | cbeneat
I did have the problem where it got into my touch screen, and had to replace it. I agree, the seals leave much to be desired. I ordered something from Mcmaster to replace what they had, so far so good. And good luck on your search, If I run into m
Electronics Forum | Mon Dec 09 21:48:36 EST 2013 | haiae
Hi everyone, I have 2 contact systems machine, one 3av and one 3avx for 3 years. I still don't know how to do dry run mode for these machine. If anyone know how to do please kindly tell me. Many thanks,
Electronics Forum | Fri Jan 17 03:06:11 EST 2014 | aemery
Hey Comatose, did you get it fixed? If you still need help I can send you the schematics (No charge). If you got the machine from a dealer they should have been able to provide all this with the machine. If you like you can call me and I can give y