Electronics Forum | Wed Apr 10 03:46:29 EDT 2019 | oxygensmd
Depends on what machine you want to get. Linux OP used on S13-S15-S20-F3-F4 for a time but they changed to WinXP - after '96. The new software with WinXp is more stable as the Lunix version. The Linux version was really sensitive of LinePC-StationPC
Electronics Forum | Fri Jun 07 11:10:08 EDT 2019 | teejsd
We also have a Foresite C3 for spot testing for ionic contamination. I didn't use it at this spot, but used it some other spots around the PCB that showed this color change and with our C3 we were passing IPC standard for ionics. But I was wonderin
Electronics Forum | Fri Jun 07 11:17:14 EDT 2019 | teejsd
Unfortunately for me, I can't say whether those balls were flat on 1 side or not -- sent this board for x-section to see if we had CAF, since my ionics testing wasn't breaking IPC standard. Unhappily my x-sect results were inconclusive. However I d
Electronics Forum | Tue Apr 09 21:57:42 EDT 2019 | alexvolovich
If you were able to do a first/last part, then your tray wagon is set-up. You need to go to Tray Types and program the tray that will match the piece of tape you have. Then you should be able to add your component to the tray wagon.
Electronics Forum | Fri Apr 12 07:40:50 EDT 2019 | krob
We have found that our wave solder will produce worse hole fill/top side fillets nearest the conveyor, on most boards. I believe this is due in part to the smaller contact patches near the conveyor fingers. What could cause this reduced contact
Electronics Forum | Fri Jun 07 04:57:53 EDT 2019 | gregoryyork
Its more than likely the conveyor is slightly out and needs dropping. You do have a fairly significant contact though so are you sure the Solder pot isnt running too cool for Lead free, needs to be around 275C for good wicking and flow or 250C if lea
Electronics Forum | Tue Apr 16 16:50:05 EDT 2019 | slthomas
That's a completely different story, I was wrongly assuming that this was a new to you but "pre-owned" conveyor that wasn't set up for your process yet. It's certainly possible that the control software allows for left to right and right to left sel
Electronics Forum | Tue Apr 16 01:42:15 EDT 2019 | ledze91
Hello. Got problems with big elements like connectors. Pickup tolerance dont work on cp40/Lv. Here got two machines cp40/lv and one cp40/cv. On cv dont have problems with pickup, but on Lv nozzle hit the pins of connectors or wont pick up
Electronics Forum | Tue Apr 23 07:08:35 EDT 2019 | robertorocco
Good morning I have a problem with start my Samsung CP40 C machine. After the start Bios win98, and Dpram Initialise, system loading , vision data loading, one icone error visualize: Error Mcp, General error SCP.Exe. Solutions? Thanks
Electronics Forum | Wed Apr 24 10:57:11 EDT 2019 | scotceltic
Thanks Steve for the candid reply. We would probably end up dealing with the rework in house so that is why I want to make it easy from the get go instead of jumping through hoops like I know a lot of EMS vendors like yourselves have to do for their