Electronics Forum | Fri Jan 05 20:26:48 EST 2024 | kristi
I am in search of a boot disk for an Electrovert Econopak Plus. First our CMOS battery died, we wired a 3V battery to it and that works fine now. However now it's saying the diskette is unable to boot. The disk drive passes test, and I have installed
Electronics Forum | Thu Jan 11 19:52:55 EST 2024 | travishemen
Check the top of the placing head. There are 3 screws around a piece that pops up when you push up on the nozzle. I had one once that was vibrating and causing the part to place slightly off angle. It is exposed to the vacuum used to pick the part
Electronics Forum | Sat Jan 27 18:25:46 EST 2024 | redspare1
Thanks for your input, new to this industry and trying to learn. Which is a better machine for low volume high mix? I have the option to pick which path to start learning on MPM Speedline Accela or a DEK 265 Horizon Any pros / cons or input is appre
Electronics Forum | Mon Jan 29 12:18:46 EST 2024 | oxygensmd
For low volume high mix an EKRA will be much better. Slower but much better on GUI which makes products changes faster. Operators can handle the machine easier and way better in effeciency. EKRA have really simply internal sturcture which makes servi
Electronics Forum | Fri Feb 02 18:06:07 EST 2024 | stephendo
We had Ekras and would lie about the size of the board. That would bring it in with an offset. It was an OEM and years earlier they had used kapton stencils. The operators would occasionally complain about an old stencil but have to wait until there
Electronics Forum | Wed Feb 07 15:31:05 EST 2024 | proceng1
We have a few custom made fixtures that use a flat disc like that and they are spring loaded. For our "homemade" fixtures, we generally use screws stocking up in the tooling holes that are cut to only stick up approx .050 on an .062 board, so there
Electronics Forum | Thu Feb 08 05:54:43 EST 2024 | 1_manuel
Thank you for your response! I think, the labels seem more elegant and offer the flexibility of being reversible if the labeling isn't satisfactory. However, the punch numbers themselves are also a viable solution, so thank you for that suggestion
Electronics Forum | Fri Feb 09 01:46:55 EST 2024 | erikfriesen
I have a 2005 DEK Horizon 02i, the cmos batt was dead, so I replaced, and reset the bios. The device hangs in initialization, eventually erroring out. The vision led's blink rapidly during this period. Also, the card shows an error in device manag
Electronics Forum | Fri Feb 09 14:28:08 EST 2024 | redspare1
Yes, I have ran into this. They won't even sell you a screw unless you give them money to "register" Trying to start for the lowest cost. I see the DEK could be harder to learn as a new person. Yes, self calibration would be great! Thanks everyone f
Electronics Forum | Wed Feb 14 17:35:16 EST 2024 | davef
SMTnet is been under DoS attack. Our programmers believe they have both a short-term and a long-term fix. Fingers crossed. You can contact me by clicking the link below my avatar just to the left. SMTnet apologizes for the inconvenience, recognize