Electronics Forum | Wed Nov 03 09:42:31 EST 2004 | dramos1
Hi Simon, Thanks for the immediate reply. We really appreciate it very much. Currently, we are using Class 2 for the visual inspection criteria of our telecom boards. In IPC-A-610 Rev. C criteria, there are TARGET, ACCEPTABLE and REJECT criterias.
Electronics Forum | Thu Nov 04 09:00:01 EST 2004 | russ
As stated by others you are out of IPC compliance, However, There are allowable deviations to the standard as long as the purchaser and manufacturer come to agreement that the non-conformance will not affect form fit or function. I would recommend
Electronics Forum | Tue Nov 09 10:44:13 EST 2004 | russ
I guess i might want to throw this in for future reference. After speaking with our board supplier he states that this mask is fully cured when it reaches approximately 180C. I beleive this since we usually probe the repaired area after putting the
Electronics Forum | Thu Nov 11 02:59:03 EST 2004 | Base
Hi Charlie, In case you're processing large quantities of lumileds you may want to have a look at the Assembleon FS machine. It is an FCM machine of only half the length with some dedicated robots on it. In stead of all Pick&Place robots it 2 dispen
Electronics Forum | Thu Nov 11 13:34:44 EST 2004 | dorklover664
Did you like the FormFlex tooling as far as support goes? I would be more inclined to spend the set up time if we got better support. As of now we have about 30min, between runs so the set up time isn�t as important as the cost and the support is. We
Electronics Forum | Thu Nov 11 23:09:35 EST 2004 | valuems
Hello There is several items that could cause this problem. And ken don't ever try to upgrade any software unless you are real sure that you have every thing on the hard drive backed-up. MPM just loves to sell the 2D codes over and over. There i
Electronics Forum | Fri Nov 12 11:07:08 EST 2004 | valuems
Hello Terry We have found that the best angle for metal blades is 37 to 45 degrees. Metal blades won't enter the stencil opening, rubber does. Metal blades are with out question the best way to print. If you go over 45 degress the blades will leav
Electronics Forum | Thu Nov 18 14:38:59 EST 2004 | EED
There is a couple of things to check. Put the machine in diagnostics and let the chain run. You should see it run the same as you would if purging it. Sometimes the 2 hall effects at the disk do not see the disk as it turns. Check the driver board
Electronics Forum | Fri Nov 19 18:02:03 EST 2004 | valuems
If it is a MPM printer you can install the environmental control unit. But it isn't as simple as most people thinks. You also have to install a thermostat inside the machine. Then there is a wire that is used to turn it on and off, this wire is fr
Electronics Forum | Fri Nov 19 15:57:05 EST 2004 | brent.robinson@donnellye.com
I agree that using floppy's would be too much hassle, especially with updates and such. Turn on your security system on the GSM and create System and Operator logins. Create a password for System and nothing for Operator. Then in order to make cha