Electronics Forum | Sun Jul 05 12:32:43 EDT 2009 | emanuel
While moving to a new location we had to remove the tables from a Philips Comet in order to be able to pass a narrow door. While attempting to calibrate the machine, during Warm-Up a strange error appears, sometimes almost immediately and sometimes a
Electronics Forum | Mon Jul 06 01:27:06 EDT 2009 | mpolak
Hi Everyone, I am having some problems with pasting. When I print a board i expect the paste deposit to be brick shaped. Nice and square. The porblem is it higher on one side then on the other. And you can tell which direction squeegees were going b
Electronics Forum | Tue Jul 07 12:11:32 EDT 2009 | naynayno
We are in the process of transitioning from OA flux to No-Clean. Because of the tighter process window there is a lot of concern about component and PCB solderability and storage. The last thing we want to do is put some solderability specification
Electronics Forum | Tue Jul 07 15:02:48 EDT 2009 | snsmt
Hello everyone, I have a question regarding rework. How do you guys rework QFPs (lead free)? The only method that we are currently doing is using a heat gun. We are heating up the bottom of the PCB (approx. 2") away from the bottom of the
Electronics Forum | Mon Jul 13 05:54:39 EDT 2009 | rway
Hello all, We are looking to purchase another AOI system with side angle cameras. Currently we are using a YesTech M1 system that has only a top-down camera (it can't be upgraded with side cameras). Does anyone have experience with YesTech F1 sys
Electronics Forum | Mon Jul 13 09:34:32 EDT 2009 | csm
Dear all, we have an Fuji CP6-4000 we get some weeks ago, but it shows an error "Hardward NG and show some actions (Inch the axis to cancel the overtravel. Then switch the power off and restart the machine). We did but display same error. I would
Electronics Forum | Mon Jul 13 10:04:06 EDT 2009 | csm
Dear all, we have an Fuji CP6-4000 we get some weeks ago, but it shows an error "Hardward NG and show some actions (Inch the axis to cancel the overtravel. Then switch the power off and restart the machine). We did but display same error. I would li
Electronics Forum | Fri Jul 17 19:43:20 EDT 2009 | fujiphil
Have you eliminated the hardware N.G.? Check the connection for the rear door. If the connection are ok, try to bypass the key. short the two wires for the rear door. If the rear door problem is corrected, check the rear door switch physically. Reg
Electronics Forum | Mon Jul 27 20:35:40 EDT 2009 | michaellaw
Just curious if anyone here has experience with a > Panasert RH6 Radial Insertion machine. Ours is > having some problems detecting insertion, appears > to be failing to sense when the legs are cut and > is triggering the error. This is the com
Electronics Forum | Tue Aug 25 08:46:03 EDT 2009 | doremiking
I've just seen your question because I list this site rarely. It can boot usually from C: hard drive, we have 4 Omron AOIs - brand new (RNS & VT-WIN2),theoretically one computer can boot from different disks, it is set up in the BIOS, there are some