Electronics Forum | Wed Jul 07 22:59:06 EDT 1999 | Dave F
| Hi! | I'm a process engineer attempting to do a capability study on our existing convection reflow oven - Heller 1500. It was recommended by an independent consultant to do at the very least, load testing, process ready testing, and board uniformi
Electronics Forum | Tue Jul 06 17:03:46 EDT 1999 | Earl Moon
| Is anyone aware of some guidelines regarding through-hole in SMT pads? One of our designers wants to add through-hole leads in some SMT pads for an inductor. The size of the hole is 0.032 inches and takes-up approximately 25% of the pad area. Th
Electronics Forum | Wed Jul 07 15:30:18 EDT 1999 | JohnW
| | We are looking for some subcontractors to do surface mount | | technology boards for us. Is there anything I should pay specific | | attention when I visit the subcontractor's site? | | Thank you for any advice | | | Carol, | | Someone bel
Electronics Forum | Fri Jul 02 14:32:44 EDT 1999 | Dave F
| I am currently looking into ways to decrease SMT changeover times. I work in a high mix-low volume factory. We use Fuji CP's and IP's for SMT production. I would appreciate hearing from anybody that has some proven methods for reducing setup/change
Electronics Forum | Fri Jul 02 14:50:39 EDT 1999 | Earl Moon
| | I am currently looking into ways to decrease SMT changeover times. I work in a high mix-low volume factory. We use Fuji CP's and IP's for SMT production. I would appreciate hearing from anybody that has some proven methods for reducing setup/chan
Electronics Forum | Wed Jul 07 08:54:20 EDT 1999 | M Cox
Snip | John, | | You said a bunch. My biggest problem running Fuji, Panasonic, or Sanyo high speed stuff is that they are meant to run free. They are meant, in my mind, to run as thoroughbreds. | | I watch 6" reels placed on feeders, placed on the
Electronics Forum | Mon Jun 28 17:03:59 EDT 1999 | M Cox
| Hey there gang, how's it going ? | | Anyway's here's my probelm, got a new product to build double sided reflow, lot's of so20's and PLcc's 1206's, 0805's the usual stuff. Probelm is all the pad spacing of the 1206's are too big, my component's ar
Electronics Forum | Thu Jun 24 15:58:46 EDT 1999 | Adam Pratt
| | Dear guys, | | | | I have some problem on assembling micro-BGA with solder paste (63/37). The micro-BGA we assmeble is 0.75mm pitch and with 45 pin (solder bump is 96.5/3.5Ag). The stencil is a laser-cut stencil with 5 mil thickness. We are no
Electronics Forum | Thu Jul 01 13:57:57 EDT 1999 | Kris Wiederhold
| Dear guys, | | I have some problem on assembling micro-BGA with solder paste (63/37). The micro-BGA we assmeble is 0.75mm pitch and with 45 pin (solder bump is 96.5/3.5Ag). The stencil is a laser-cut stencil with 5 mil thickness. We are now usin
Electronics Forum | Fri Jun 25 09:51:35 EDT 1999 | C.K.
| Dear John/Earl | | Thanks for your clarifications. To me also the problem does not seem to be linked with the PCB. The Pre heater temp. is set at | 450 degree C. We are using Alpha Aq. cleanable flux. Can you elaborate on the Desired profilin
