Electronics Forum | Wed Jan 23 08:41:42 EST 2008 | operator
Actually we don't have local fume extraction at our soldering stations. We have 4 going at a time. I was researching last night and found this website. http://www.engineeringtoolbox.com/air-change-rate-room-d_867.html It indicates 10-15 air changes p
Electronics Forum | Mon Jan 21 12:06:47 EST 2008 | sliebl
As others have said, Bliss racks are not cheap, but they sure are nice. We are a small single shift shop, but we have 4 of their carts. Two for stencils and two for feeders. Even fully loaded these roll very nicely if you need to get them out of the
Electronics Forum | Wed Jan 30 15:42:14 EST 2008 | mmjm_1099
Hello all, Got a new XP242 in house and noticed the vision system is way different than the QP341 we have in house. I am looking for someone to network with in regards to any questions I may have in regards to the XP242. I have talked to Fuji and the
Electronics Forum | Fri Feb 01 01:46:46 EST 2008 | jola
Hi. There is no problem with the exhaust system and the owen also has a sensor to messure the exhaust and would give an alarm if it stopped or went under a preset value. We have had our owens for one year now and the problem just started suddenly, we
Electronics Forum | Mon Feb 04 15:24:24 EST 2008 | kpm135
Thank you very much for the input. The Siemens route is actually one we have looked into but I guess our CEO had a bad experience with some Siemens machines some years back and is now rather turned off towards them. I myself have looked at the new Un
Electronics Forum | Mon Feb 18 17:18:54 EST 2008 | slootj
Has anyone experienced problems with using Titanium pallets when they get hot? I have a product that solders with no defects when the Ti is first used or warm but then have leads that are not soldered when the pallet is hot. By hot I mean it has been
Electronics Forum | Sat Mar 29 15:29:06 EDT 2008 | aw
I am printing a ceramic paste through a 160 mesh screen that should have a theoretical wet print thickness of 53um but the only way I can get the print that thin is to increase down stop and slow the stroke. This is causing problems with the mesh, s
Electronics Forum | Tue Apr 01 08:28:19 EDT 2008 | cyber_wolf
DANGER WILL ROBINSON ! DANGER ! If your operators are not real careful the OEM support pins can get under the table frame and bend it. I have seen this happen more times than I would like to discuss. CP's must have the following: 1. Proper part hei
Electronics Forum | Tue Apr 15 03:16:14 EDT 2008 | janz
Hello, We are having a problem with soldering QFP100 (16mmx16mmx1mm). Board dimensions: 70mmx50mmx1.8. FR4 two layers � single SMT assembly. Finish: HASL-lead free Oven: 7 zones �hot air Paste: lead free We have noticed that two groups of legs
Electronics Forum | Wed Apr 16 15:38:46 EDT 2008 | ck_the_flip
This person needs to have the "mental faculties" and a basic understanding of science, and understand concepts like flux, solder paste, time vs. temperature curves, etc. Do they have to be a metallurgist?? Of course not, but at the minimum they hav