Electronics Forum | Fri Jan 25 12:14:18 EST 2013 | johng
I'm using urethane conformal coat and have fisheyes and dewetting after coating even though the PWAs have been through the wash cycle twice. I'm looking at using Ionox 13302 in an ultrasonic cleaner as a short term solution until root cause can be id
Electronics Forum | Fri Jan 25 12:15:04 EST 2013 | johng
I'm using urethane conformal coat and have fisheyes and dewetting after coating even though the PWAs have been through the wash cycle twice. I'm looking at using Ionox 13302 in an ultrasonic cleaner as a short term solution until root cause can be id
Electronics Forum | Fri Jan 25 14:20:31 EST 2013 | jorge_quijano
Hi there, I have a new product today, after reflow oven I've seen a black stain coming from various holes, they can be cleaned with a tissue but some of the contaminant remains inside, we are using Sn63Pb37, the stains are far from soldering areas, t
Electronics Forum | Mon Feb 04 11:01:44 EST 2013 | bobpan
The way its supposed to work...is....when you do a function 30 the z axis should step down until the nozzle tip is seen in the quad align or laser align. The readout should have a nozzle height but if its the earlier firmware for the machine it might
Electronics Forum | Mon Feb 04 23:27:01 EST 2013 | armandogomez
Hello all!!! I have a question, since we first started here we have bought a lot of ICT fixtures for our old Z1820 teradyne we are a company that work with a lot of reed switches, no the question is can a reed switch be tested in the ICT? I have no
Electronics Forum | Tue Feb 05 20:31:39 EST 2013 | hegemon
Air Vac DRS25. Hands down the best rework EQ. (my humble opinion, based on my own experience with rework EQ going back 15 years +) Right in your budget. Complete capability for rework. SMD, BGA, POP. Full profiling capability. Massive bottom heati
Electronics Forum | Thu Feb 21 08:20:43 EST 2013 | cowens
Thank you so much. We actually did get the machine up and running yesterday morning. We switched the theta and the transport driver cards and it is working now. We have had the connectors burn on us in the past and replaced them. I am hoping the prob
Electronics Forum | Mon Feb 18 13:53:44 EST 2013 | cbeneat
We have some Vectorguard stencils and frames. I am having issues with one of the frames. And need a little guidance. A stencil is on the frame, and we can't get it off, the operator heard a pop while putting the stencil on the frame, now we hear a
Electronics Forum | Tue Feb 19 11:43:52 EST 2013 | markhoch
I'm not sure of the timeframe with which you have to work, but I'd consider sending the frame and mounted stencil back to DEK for repair. I'm not a huge fan of these systems, because I believe consistancy in the process is critical, and these system
Electronics Forum | Thu Feb 28 11:02:31 EST 2013 | hegemon
1. Read the manual. It's pretty good, and an easy read. Most tech guys could read the manual and have a good start. 2. Call Mirtec, they should connect you with a local rep. who may or may not have some machine knowledge. They may want $ if the m