Electronics Forum | Thu May 27 13:18:30 EDT 2004 | swilson
Hello does anyone have a schematic or service manual on setting up a foam fluxer on the 650C wavesolder machine. I am concerned with the two pumps in the rear of the machine what are the connection for on the pumps. I do have the manuals, but they do
Electronics Forum | Tue Jun 01 15:42:33 EDT 2004 | James
We use them on our DEK printers. They have worked out very well. The only thing we had to do was make a push down bar so we could push all the pins down and lock them. This makes setting up the blocks much easier; board is fixtured, pins released
Electronics Forum | Wed Jun 02 19:17:15 EDT 2004 | valuems
Hello Black The problem that you are having is a common one. There is several things that can cause this problem. If your still having problem's you can call and we will talk you thru it. We will not try to sell you any thing and will not charge y
Electronics Forum | Wed Jun 02 09:10:30 EDT 2004 | dougm
My company is looking at the various options for selective soldering machines. We are mostly a low volume, high mix facility, with some moderate volume orders as well. I have looked at the Pillarhouse Topaz XL, Ersa Versaflow, and Vitronics Soltec
Electronics Forum | Fri Jun 04 14:03:18 EDT 2004 | Frank
I know Juki has the headquarters in NC, but they have a support office in the Silicon Valley with spare parts. I know they go to the NW area quite often from that office. They offer their customers 7-day/24-hour free phone support (including holida
Electronics Forum | Fri Jun 04 19:59:18 EDT 2004 | Ken
Well, if they were "Field Service Engineers and couldn't fix a thing...how did they get hired"? And if this is the case then I would have to question the company's judgement and determination of my best interests for sending an unqualified, untraine
Electronics Forum | Mon Jun 07 14:47:22 EDT 2004 | Mark
It matters on how you setup your oven profile. I have placed J-leads on both sides with no problems. Also, have come across some fine pitch but wouldnt suggest this too often. Give some examples that he would like to see placed on the bottom side of
Electronics Forum | Mon Jun 07 21:31:46 EDT 2004 | davef
That's thin board. The test that you ran is the best method for determining the specific answer. Bob Willis says, "Use pad mating to lead wetting area. Some have found the ratio to be as much as 44 grams/sq in." Bob Willis and Phil Zarrow have po
Electronics Forum | Thu Jun 10 11:20:03 EDT 2004 | bbarr
I have been given a v-groove score keep out area dimension of 1mm from the edge of the groove to the component body; except the dimension becomes 5mm for ceramic components. 5mm seems like a very large value. Does anybody have experience with this? I
Electronics Forum | Mon Jun 14 11:44:23 EDT 2004 | Dreamsniper
I have boards with bad HASL application. First they're not even. Second some pad edges have no HASL and still remains bare copper. What's the maximum and minimum HASL thickness required for a good solderability. My boards are about 6 weeks old, I kno
