Electronics Forum | Sat Sep 29 19:04:13 EDT 2012 | e_music
Hello, I have just installed the demo version of GC-Powerplace. Could anyone here walk me through the process to generate pick and place file from gerbers? I don't have solderpaste layer. All I have got is signal layers (top/bottom), soldermask, sil
Electronics Forum | Fri Nov 02 17:57:59 EDT 2012 | hegemon
We have 2 ACE machines running 2 shifts per day, 6 days a week. Maintenance costs have been minimal. Performance very consistent. Great machines for the $$. Certainly not complex. Hence the K.I.S.S. logo. I don't have any experience with the "big
Electronics Forum | Mon Jan 28 11:22:46 EST 2013 | rway
Does anyone have any experience with these buffers? I have one that has come up with an error message "No PLC Driver." According to the documentation, the issue is the lithium battery in the operator interface. I have confirmed that the battery is
Electronics Forum | Mon Feb 04 11:45:51 EST 2013 | wolverine
I do basic machine maintenance, have been asked to look into swapping out heads between two older Samsung CP40 machines. I have said that attempting this is not advisable for the following reasons: * I do not have access to Samsung Technical support
Electronics Forum | Mon Apr 01 08:09:36 EDT 2013 | babe7362000
We currently have an AOI after reflow, and I was wondering how others have thier line setup? Does the AOI operator have to get up and get a board from the oven to run, or should the SMT operator hand the AOI operator a board. The AOI operator does
Electronics Forum | Wed Jan 29 10:23:24 EST 2014 | alphatronique
Hi i have strange issue on one of my TM8FC feeder feeder seem to have 0.5 to 1mm longer that my other feeder on image above have 2 side by side picture was take on same machine slot ,and both feeder have same part separation clip i even swap cl
Electronics Forum | Thu May 01 14:20:54 EDT 2014 | rway
From my perspective, the installation phase of the project is part of the training, as you have alluded to. Part of this training is informing the customer about the necessary tools to perform testing/calibration/maintenance on the machine. This is
Electronics Forum | Wed Jul 30 23:40:45 EDT 2014 | matusov
Yes, but I have seen designs where the whole row > of leads has no mask(which is also a NSMD) Apparently I might have to do just that for some parts. We have a few parts with 0.2 mm pads at 0.35 mm pitch. Our PCB shop says that they need at least
Electronics Forum | Tue Feb 03 02:55:04 EST 2015 | max83
Hi, > > We have a snap-off issue. I guess it can > be linked to z calibration. > Hi, > > We have a snap-off issue. I guess it can > be linked to z calibration. > Hi, > > We have a snap-off issue. I guess it can > be linked to z calibration.
Electronics Forum | Tue Feb 24 15:52:58 EST 2015 | swiese242
We currently have around 20k+ components in stock. I would like to have some opinions on creating a more lean manufacturing system. We check stock in our system and then order parts. Most of time leading to employees looking for parts, or shorts. We