Electronics Forum | Mon May 16 19:57:51 EDT 2016 | rx8pilot
I recently purchased some used ThinPRO precision feeders for my Quad IV-C (PPM 4000C). They are in great shape, but I do not know how to program them to index at 2mm Does anyone have experience with these that know how to program them? I can only go
Electronics Forum | Tue May 24 05:52:09 EDT 2016 | nikkilouie
Hi everybody, right now we are having a second hand machine of philips. the topaz and eclipse and unfortunately it dont have any manuals and no one from our team knows that machines. so im looking for anyone could give any user, programming and parts
Electronics Forum | Tue Jun 07 12:17:15 EDT 2016 | lilblevs11
Does anyone have a good answer to lifted components? I read on this site (old thread) that someone designed bean bags to set on top of a PCB to keep the components down on the board. I know that seems like a short cut to eliminate lifted components
Electronics Forum | Mon Jul 11 10:59:50 EDT 2016 | mnorthey
Other problems on previous machines that we have experienced is that there was not enough board support under the panel or that the panel thickness was inaccurate. Both situations can cause parts to bounce off the PCB or not to be pushed into the pas
Electronics Forum | Mon Jul 11 13:21:40 EDT 2016 | bradholland
well there you go. I found that trying different values in the "Placing Stroke" had a big effect. I changed it to 2mm and it placed them well, but I could see the board also flexing a little, went to 1mm and the problem came back, so have sat in th
Electronics Forum | Tue Jul 12 10:33:24 EDT 2016 | dontfeedphils
I'd start by checking and reteaching the nozzles (this is automatic, it'll measure the nozzle length and vacuum values for each nozzle). After that double check the value you have entered for the PCB thickness as this will impact where the machine t
Electronics Forum | Mon Jul 18 22:31:25 EDT 2016 | cmchoue
Hello, Experts I have a question about Through hole SMD part in SMT process The PIN Length can't over PCB board how many that will happen defect? any advice or data(IPC rule maybe) ? Thanks Wish you have a nice day
Electronics Forum | Wed Aug 17 06:30:50 EDT 2016 | thaneshsivanadian
Hi Guys, i have some doubt, may i know how to calculate the PCBA warpage after complete of SMT and through hole process? Do we have any calculation for that? And What is the acceptance level of warpage after complete assembly? Thanks, Thanesh
Electronics Forum | Thu Aug 18 02:39:21 EDT 2016 | epsltd
We have a Mirae 1030 and when the machine warms up the y-axis fails and we are unable to reset servos unless we leave machine powered down few hours. Now since we have changed servos after machine homes we jog the y-axis and it vibrates and very nois
Electronics Forum | Sat Oct 01 15:51:54 EDT 2016 | mnikhilesh
I have seen a small nickel pad (probably) soldered on PCB which is used to spot weld the other nickel strip coming from battery. I have seen them in chinese protection boards. I need to know how and where I can find them? Is there any technical name