Electronics Forum | Mon Apr 01 10:09:03 EDT 2013 | markhoch
It sounds as if you have your AOI set up off-line, and you're "AOIing" a sampling of the PCBs produced. If that’s the case, then the responsibility of who drives the inspection really depends on how you configure it. If it's based on the number of P
Electronics Forum | Fri Apr 05 07:17:55 EDT 2013 | leemeyer
I've never seen one but i've been told that there is a 2 tier vib plate where the top plate is set back a bit so that the nozzle can pick from the top and bottom plate. OK so you have the plates on the machine and have entered their coordinates. Cl
Electronics Forum | Mon Apr 08 07:20:56 EDT 2013 | leemeyer
What operating system are you using ? I have found that you need to stay with a DOS based operating system. I am running DOS 6.2 with windows 3.11. I tried win 98 and although it seemed to run properly, I would have problems in the final program. XP
Electronics Forum | Mon Apr 29 12:32:18 EDT 2013 | stephendo
Do you watch when it is doing the wave height test? Watch it and see if it goes up to the same spot on the test probe each time. If the test probe is dirty sometimes the solder has to go up higher on it before it gets detected. You might actually be
Electronics Forum | Tue May 07 10:14:00 EDT 2013 | tanderson
I'm trying to minimize the loss of parts due to dropped parts. Part of the problem might be I'm filling in until we replace the SMT supervisor/manager. Some dopped parts are expected and are so inexpensive it's not worth fussing over. Sometimes I fee
Electronics Forum | Fri May 24 09:34:57 EDT 2013 | markhoch
I run the same profiles for Top and Bottomside assemblies for all of my products. Only in rare instances have I been forced to run a profile with cooler bottom zone settings. This was obviously driven by assemblies with heavier components on the bott
Electronics Forum | Thu May 23 18:05:07 EDT 2013 | hhaase
I'm going to be acquiring an older Kirsten Jet machine in the near future, but am having a bit of trouble locating a source for appropriate wave oil / ADL via a domestic US source. Their current recommendation is a product from Strub in Switzerlan
Electronics Forum | Fri Jul 26 13:11:06 EDT 2013 | gallionc
I think we are all on the same page with this one. Since you ran from 96 until now without any issue I'd say that now you know what causes the problem, make a note of it for next time and move on. I have found with our older machines that "if it ai
Electronics Forum | Wed Jul 03 09:13:23 EDT 2013 | dontfeedphils
I currently run the HLC software suite with a 750/760 line and another 2060 line. For the 750/760 line I have to stick with the older HLC, version 4.5 I believe, which I actually run inside of a Windows 98 virtual PC using a dongle emulator. The 20
Electronics Forum | Sat Jun 07 13:46:43 EDT 2014 | ipdisplays
Hi All, I know that is thread hasn't seen activity in a year or so... I'm having a similar issue in configuring a line. I see that the IEC addr is called version in the real.ma file. This is not helping me since I apparently have two machines that