Electronics Forum | Thu Apr 20 03:46:26 EDT 2006 | aj
Hi Jon, Thanks for that. I seem to be having a problem getting a unit on Trial. I have plenty of access and my main priority is to reduce the amount of dross (or may I say Solder) that we send back as Dross, I am based in Ireland so I have to go t
Electronics Forum | Mon Apr 24 07:37:57 EDT 2006 | craig_83
We have the IQ system. The problem that I was having is that when I load one board to the other, I want to avoid the table top changeovers. So I figure if I can make certain tabletops to run certain boards the changeovers would be much less. I though
Electronics Forum | Wed Apr 12 06:40:11 EDT 2006 | aj
All, I continuosly have reliability issues when placing a SOT363 device. I have Fuji CP6 and CP4 placement machines. The part data has been analysed down to the finest detail but it is still hard to maintain any consistency. Anyone else have simi
Electronics Forum | Mon Apr 24 04:21:10 EDT 2006 | vpha
I have seen a Spark 400 at Apex Show. It appears to be a good Machine to do rework on BGA and others. I have used a SRT Summit 1100 Machine to do most BGA Reworks and want to have a Machine which can do rework better. Does anyone has any knowledge
Electronics Forum | Sun Apr 30 16:56:22 EDT 2006 | mrduckmann2000
I am sure that Fuji will transfer the ownership, it will cost some money but they will do it. I have been with a company that has had to transfer Panasonic equipment to 3 different owners over the last several years. It cost approx $10k to do the t
Electronics Forum | Tue May 02 11:50:53 EDT 2006 | Rob
Good point Grant, but also to be fair some of our USA suppliers have also been very good in the Leadfree change over - Kemet, Microchip, Lattice, & Diodes Inc to name a few, whereas a the attitude of a couple of our European suppliers have left a lot
Electronics Forum | Wed May 10 13:21:58 EDT 2006 | scombs
Thanks for the reply. We have carefully inspected the part and solder joint after depaneling and all looks good. What is weird is if you remove the part from the board and check continuity with a meter you have a dead short. If you put on a new part
Electronics Forum | Mon May 15 01:21:44 EDT 2006 | eeltec
Help: I have a cartesina robot brand Shibaura Engineering Works Co Ltd (now Toshiba) model AMI-A2R40A. I do not have any manuals so I do not have a programming reference manual. I will thanks any information; a user manual or a lenguage short list or
Electronics Forum | Mon May 15 08:53:52 EDT 2006 | aj
Hi All, Due to carry out the Bath Changeover this weekend. I have an Electrovert Econopak- 550 kg bath. We are not replacing our internal components i.e nozzles/pumps etc. until we really have to. Has anyine carried out there changeover yet and ha
Electronics Forum | Tue May 16 11:58:27 EDT 2006 | jsloot
What is the best or ideal cleaning method for wave solder pallets? I have been using iso prop and am not sure if this is the cause for having brittle wall material. I wouldn't think alcohol would degrade the durastone material. Most of my pallets hav
