Electronics Forum | Sat May 06 06:19:36 EDT 2017 | rob
You could also try some of the 3D MID placement machines - some have dispense heads in with the placement heads, so theoretically you could place on the PCB paste, dispense on the terminals. and place the new part. Yamaha/I-Pulse do a couple: https:
Electronics Forum | Mon May 08 10:21:15 EDT 2017 | sumote
I know this may be a long-shot, but I can really use the reach this forum has. I am looking for an injection molding material called Noryl. The specific compound is SE1X-71944. If you have any of this available, or know someone that does, please repl
Electronics Forum | Wed May 17 02:32:39 EDT 2017 | bukas
Rob explained very well what it takes to start SMT line. The question is what infrastructure do you have at your factory? any category Rob mentioned can have time consuming complications and this is why you should find professional to start the SMT
Electronics Forum | Mon May 22 09:35:07 EDT 2017 | emeto
There is one lead that is a total miss. I think you are too low with the wave there - you are barely touching the board. I would say first look at your wave height. If you have the possibility to change the angle of the wave(if there is a backplane t
Electronics Forum | Tue Aug 01 18:28:47 EDT 2017 | zsoden
Thanks for the suggestions. 1. By this are you referring to the flux specifications or the actual profile of the machine? 2. Yes, the entire machine, the solder pot and the wave nozzles have all been levelled. The better joints on one side are perp
Electronics Forum | Tue May 23 07:02:08 EDT 2017 | bk
No matter what machine that you decide to buy some of the things you want to know especially concerning used machines are how readily available are spare parts for the machine. How hard is it to program the machine and are there programs available to
Electronics Forum | Tue Jul 18 03:11:48 EDT 2017 | tsvetan
I recently bought: PCB Loader, Full Automatic Printer with vision with 10 seconds print time, 1 meter Inspection Conveyor, Samsung SM482+Feeders, 1 meter Inspection conveyor, Reflow oven for similar budged, all machines new. I bought them directl
Electronics Forum | Fri Jul 21 14:47:53 EDT 2017 | sumote
I commend you for doing your diligence. It sounds like you have a solid plan, and a few decisions to make. I have used Assembleon machines before, a Topaz X and a Emerald X. They seem to be a good compromise between speed and cost. If you are close
Electronics Forum | Fri Jun 02 11:11:11 EDT 2017 | jsmith145
Does anybody have any information regarding an Omegameter 500 (Kenco Industries)? We’ve run 4000+ tests with this machine and all have produced a pass result without a single failure, starting to wonder if tests aren’t accurately assessing PCB cleanl
Electronics Forum | Tue Jun 20 16:41:12 EDT 2017 | kkrestchmer
We have a Speedline Electrovert Bravo 8 reflow oven. We have issues where we get a "thermal runaway HTSC trip" error and the oven shuts down. We normally can unplug and replug a connector into the Sensor/Relay Watlow AnaFaze TLM-8 module and it sta