Electronics Forum | Tue Jan 08 17:25:17 EST 2002 | davef
Stephano: Since you have not thought through this, it indicates that your discrepancy reporting and resolution process probably requires critical review. Consider highlighting this issue to your quality assurance staff.
Electronics Forum | Wed Jan 09 17:03:44 EST 2002 | rob_thomas
We follow IPC-2221 recommendations for Au and don't have a problem as long as the Ni is under 150 microinches.This ensures a consistent process for us.Also we do plasma clean after SMt and prior to wirebond.That makes a big difference. Rob
Electronics Forum | Thu Jan 10 07:08:04 EST 2002 | Dmitry
Hi! Try Philips / Assembleon http://www.assembleon.com and DEK http://www.dek.com. I have experience with them and like their service very much! They are very attentive and professional, even if you are located in CIS countries.
Electronics Forum | Thu Jan 10 12:02:14 EST 2002 | mparker
What is the expected volume to be outsourced to the US and where are your distribution sources? Do you have a particular US region in mind? I'm in Northern California - if you are interested in producing here, we can talk further offline.
Electronics Forum | Tue Jan 15 12:20:16 EST 2002 | cfraser
This sounds like it could possibly be a case of Black Pad. We have had a few issuses with this in the past as well. Who the PWB vendor? I also recommend searching the archives and doing some solder samples with nonpopulated boards
Electronics Forum | Wed Jan 16 13:09:41 EST 2002 | jhingtgen
Yannick, I have been involved in a stencil consortium that looked at stencil design, technology, and paste as variables. This material will be presented at APEX 2002 in San Diego next week. This work was done by Rochester Institute of Technology i
Electronics Forum | Tue Jan 22 20:37:48 EST 2002 | davef
Try: * Searching the fine SMTnet Archives. We have ground profiling, thermocouple attach, etc. to pulps. * Buying [ http://www.ipc.org ] IPC-7530 - Guidelines for Temperature Profiling for Mass Soldering (Reflow and Wave)
Electronics Forum | Sun Jan 27 16:19:09 EST 2002 | Rix
Does anyone have a good idea of a simple (GCSE standard) electronics project for a product that can solve a problem, e.g. Temperature controlled fan to cool down a PC. Please post your ideas. thanx
Electronics Forum | Wed Jan 30 06:45:01 EST 2002 | yaq
Hi, Has anyone done some research (measurement/simulation) on the effect of PWB vias on solder ball temperature of the component? Would this have some effect on solder joint reliability especially during power cycling? Any comments will be appreciat
Electronics Forum | Wed Jan 30 09:37:28 EST 2002 | clarkk
Does anyone out there have experience dispensing solder paste with a Universal GDM (4716AL) with positive displacement pumps? I'd like to hear any comments on the success or failure of the machine to dispense consistently, effect of temperature varia
.gif)
