Electronics Forum | Sun Aug 11 18:53:53 EDT 2002 | edmentzer
Chris, could you tell me which brand of selective soldering machine you are using? We are looking at some machines at this time and I would like to which vendor has the best support. I have looked at RPS/TYCO and Vitronics.
Electronics Forum | Wed Jul 31 13:09:17 EDT 2002 | gdstanton
Anyone have experience with Indium NC-SMQ92J solder paste used in an inert (N2) reflow oven?
Electronics Forum | Thu Aug 01 04:12:39 EDT 2002 | jk
Anyone have experience with BGA mount on via hole in pad. I'm encountering about 1 to 2% yield loss due to BGA solder short. This is an entek PCB. The BGA pad size is 32 mil, and the via hole (dia. 10 mil) is at the center of the pad. Any professiona
Electronics Forum | Wed Aug 07 19:41:34 EDT 2002 | ralugg
Thanks Dave and Steve, Your answers have will close this issue on Medical Pcb assembly and component specifications. your time is greatly appreciated.
Electronics Forum | Tue Aug 06 11:08:53 EDT 2002 | kenbliss
Hi Brandon There are at least two reasons to calculate down time on each machine. One is to know if the individual machine is having ongoing problems and either needs to be serviced or replaced. I doubt this is much of a problem for most machines.
Electronics Forum | Wed Aug 07 12:39:41 EDT 2002 | cnoonan
I am looking for information on tape and reel equipment. My company is having an issue with components supplied in sticks, and I was needing to get some info on either purchasing tape and reel machines or find another avenue, such as out-source the
Electronics Forum | Wed Aug 07 17:37:48 EDT 2002 | larryk
ChrisN, We have been using a tape and reel machine from V-Tek http://www.vtekusa.com for the last couple of years. It's a simple machine for small quantities. They also do tape and reel services.
Electronics Forum | Sun Aug 11 22:28:07 EDT 2002 | jersbo
a: charges are typically set by how many different part numbers you have(setup).. and how many placements there are(ie number of locations parts are to be placed) if there are 3 machines inline that does not matter.. its the amount of parts placed an
Electronics Forum | Mon Aug 12 18:44:50 EDT 2002 | dragonslayr
sounds like a couple of goofballs held an impromptu frisbee contest in your receiving inspection area. As likely a cause as any, given the limited information you supplied. Plus, you have already decided that it is not your fab house, so what can con
Electronics Forum | Tue Aug 13 16:47:22 EDT 2002 | mick
The residues are from the flux, not adhesive. Do you have flux management system in oven? You also need to check the flux type = can you use low solids. The effect is the same as steam in bathroom - it is cooling affects in exhaust and flux reforming