Electronics Forum | Sun Aug 25 14:39:48 EDT 2013 | empac
We are looking for a FUJI IP3 Technician Immediately . Please contact us if you have experience with IP3 machines .
Electronics Forum | Mon Jun 16 11:36:28 EDT 2014 | bobpan
Are both red and green leds on for the driver cards (they are located in the bottom right of the machine). If they are both on then you have an interlock opened. If this is the case....check the side doors....sometimes they are not shut all the way.
Electronics Forum | Wed Sep 04 13:25:28 EDT 2013 | charliedci
Try cake decoration websites. They have nice wooden handled, aluminum, rounded 4-5" blades.
Electronics Forum | Mon Sep 23 14:26:27 EDT 2013 | joekirin
On machines such as MyDatas you have the ability to mechanically center parts rather than optically centering. If your machine is capable of doing mechanical centering that would eliminate the need for the vision analysis. -Joe
Electronics Forum | Fri Sep 06 12:49:45 EDT 2013 | nophsem
OK my friend, thank again! so... get to work!!! laser+dispenser!!! very good challenge! ;-) Have a nice weekend!
Electronics Forum | Thu Sep 12 08:29:50 EDT 2013 | williamaxler
In my past we have used grease that we put in the connector before potting. The grease would keep the potting from flowing into the connector.
Electronics Forum | Fri Sep 13 06:48:51 EDT 2013 | JB
Hello, anyone know whats wrong with our Pick & Place machine? we have a Samsung CP40CV and on head 3 its is getting a lot of vibrations and makes the full head vibrate, sometimes it make a noise from the vibrations.
Electronics Forum | Wed Sep 25 12:44:23 EDT 2013 | Chris
You have to make sure the tape is covering the holes on the tape/carrier, this is where the sensor reads it.
Electronics Forum | Sat Oct 12 07:54:29 EDT 2013 | mandysmile
Dear Leeg, Can you pls share me your email, then i have detailed info for you. Yours Most Sincerely Mandy Yu Skype ID is mandysmile111 mandysmile111@gmail.com www.pcbconnect.se
Electronics Forum | Fri Sep 20 11:57:47 EDT 2013 | emeto
It will be very hard to find anything on this prize. You also have to know that if the machine cost is 15k, the feeders cost might be about the same amount or even more. Even manual placers will probably cost you more. Just try to change the budget.