Electronics Forum | Mon Oct 28 15:13:44 EDT 2013 | larrygroves
It will require an alignment. The tools are usually included in the toolbox, one L shaped magnetic tool, a small square glass plate and there is a tool in the nozzle changer. You can buy them seperately if you dont have them. There is a bigger qu
Electronics Forum | Mon Oct 28 12:12:58 EDT 2013 | dhruv_trylene
hi all, Could anyone kindly share the part data file/library for the fuji flexa software please? being new to this assembly world, i would like to have fewer part rejections due to part data and thus any tips/suggestions in this regards would be hi
Electronics Forum | Wed Oct 30 10:35:23 EDT 2013 | vleasher
I was looking for thick polyimide discs that are usually applied by a connector manufacturer for a pick surface. Every disc I have found online is .001 thick unlike the more rigid ones. We are hoping to find a source so we can manually apply to some
Electronics Forum | Mon Nov 04 13:10:20 EST 2013 | pradeep_selec
Hi, We have an issue of 0805package Inductor falling apart from the circuit. We are not sure about the cause for the same so I would like to get suggestions from those who can share their experience / expertise. Is the pad requirement different for t
Electronics Forum | Wed Nov 06 12:58:56 EST 2013 | bobpan
The key to figuring out mirae machine failures 'most of the time' is found in mr-terminal. Is this message from mr-terminal or is this the windows/program software error. Mirae 1010 machines have boot failure problems often. Sometimes if the z positi
Electronics Forum | Fri Nov 08 18:32:39 EST 2013 | hegemon
Dave is right, though apparently a bit grumpy today. What he's saying is that the ring de-wetting is a bad thing, and should have been called out by your lab. You might consider a lab change in the future. Some information about your processes, an
Electronics Forum | Mon Nov 11 10:51:40 EST 2013 | dyoungquist
Are you using lead or lead-free solder? 260C would be good for lead solder but may be a bit low for lead-free. We run our lead-free selective solder pot at 300C although we do not have any pre-heat or top heat, just hot nitrogen blowing around the
Electronics Forum | Fri Nov 08 10:06:24 EST 2013 | zrunkle_api
I have a small resistor pack that I need to place(EXB-N8V510JX). It has Concave terminals not sure how with any of our equipment how to make a terminal with a half circle cut into it. Any help would be great.
Electronics Forum | Sun Nov 10 09:58:38 EST 2013 | kumuda
We have been using a circuit board in the assembly of HV Tank used in X-ray generator. This board acts as a sealant to the oil tank opening. The top side area of the board which comes in contact with oil is conformal coated to avoid oil leak. However
Electronics Forum | Wed Nov 13 15:33:08 EST 2013 | mondalaci
Good question :) I'd say with a machine that is available for an average pick and place operator nowadays. Our manufacturer is not fixed yet, that's why I don't have any specific. On a related note I'm wondering whether the machine is so importan