Electronics Forum | Wed May 25 07:20:26 EDT 2016 | jasper
Dear Sir, We have the complete original manuals for you from our stock. Please send me your company name, your name, address, email and I will organise the manuals for you. Jasper (EUROPE-SMT, your no. 1 Assembleon specialist worldwide) jvanmeerten
Electronics Forum | Thu May 26 15:13:47 EDT 2016 | bobpan
If there is dust (on the glass) off from the center of the lens it will add it to the part when scanning it and place off. I have ran into this twice.....I fixed it once by breaking the lens on the quad align and blowing it out.....another time I hel
Electronics Forum | Thu May 26 15:16:28 EDT 2016 | bobpan
oh ya....i forgot....to verify this....turn off all the extents for the parts and just pick them and place them....if they are very close to where they should be then it is the quad align causing the problem....this is how you can verify it. Copy the
Electronics Forum | Thu May 26 12:46:29 EDT 2016 | tombstonesmt
Good work! We have a product we've been using a table top latex masking robot we built in house to mask keep out areas. If we could apply what your doing we can eliminate the buffer of dry time on the masking. Any information you can provide on the
Electronics Forum | Thu Jun 02 04:20:58 EDT 2016 | jasltd
Thanks, I have managed to get a step further and now get the additional info on the error that it is node 1. All cables are connected, will double check the power but I believe it has power, I seem to be able to drive everything in diagnostics mode
Electronics Forum | Wed Jun 08 08:14:48 EDT 2016 | lilblevs11
Some of our components cannot be cut and clinched. We do use one but some of the leads are too thick to clinch. I was thinking the same thing about the bean bags being on top with top side preheaters. That was one of the reasons I wanted to explore
Electronics Forum | Sat Jun 11 03:26:20 EDT 2016 | nagesh
Hi, I have problem with one of the BGA Top Cap Detached from the Solder Balis attached to the BGA. Advice /Suggest why the Top Cap Has come out. We produced 4150 Pieces & had similar problems with 5 Pieces. Thx in advance for all your suggestions. T
Electronics Forum | Mon Jun 27 11:01:58 EDT 2016 | mufflerbearings
From the pic, it looks like you have a bad board; ENIG process issue. It used to be called black pad for SMT but I'm sure it's the same condition for T/H. Any good electronic lab should be able to id the black stuff. I would also send raw boards bac
Electronics Forum | Mon Jun 20 14:01:37 EDT 2016 | babe7362000
Does anyone know of anyone that would inspect our Finished PCBs using photos for their software, instead of shipping out the PCB's? We have boards that are quite heavy. We need them inspected for thru hole accuracy. Or if you know any software th
Electronics Forum | Wed Jun 22 15:35:09 EDT 2016 | mikemoriel
Hi all, I have a problem on my 265 GSX printer. "Position error" on the rising table. Machine was running fine and then out of the blue the error occurs, takes a few power downs and not working... The table does not move then error occurs...