Electronics Forum | Mon Jun 18 09:44:22 EDT 2018 | sarason
OpenPNP will not get you to your end goal. Dockerty electronics has an open source solution in Delphi that could be modified for our purposes. http://www.dockerty.co.nz/index.html Madell I believe have something in hardware with 5 feeders that wo
Electronics Forum | Mon Jun 18 09:52:42 EDT 2018 | robl
Seen a fair few SMT programming houses with modified Quads and Versatronic machines. We had a play at this too, and didn't look too taxing. We have an IC that takes 40 mins to programme, and the programming house runs through the night, gang prog
Electronics Forum | Tue Jun 26 20:44:14 EDT 2018 | deanm
We have four QSV-1s, all with the Windows 7 upgrade. Although they do the job for us and they are still fully supported, I would not recommend them for anything less than 0603. For 0402 and 0201 you need special feeders. We do not use the special fee
Electronics Forum | Fri Jun 29 09:04:41 EDT 2018 | kdexter0928
Wow, its that much slower? If it were my decision we wouldn't be going from one old platform to another. As you said budget is the problem in this case. I am not sure that they want to spend the money on this let alone something newer. They would lik
Electronics Forum | Sat Jun 30 06:02:46 EDT 2018 | ali_jayyad
Hi, I was wondering what is the difference between MP and NO at the end SMT part number. I tried to look into it but could not find anything promising. e.g I have a resistors with part numbers 0603-NO and 0603-MP and 0603-RES. What could be the diffe
Electronics Forum | Wed Jul 18 07:11:22 EDT 2018 | ir11
Dear SMT Experts, Just want to seek for expert advice regarding Ceramic PCB. Our Customer want to run ceramic PCB and want to understand the challenges that we might encounter. Anyone have their experienced running or dealing with Ceramic PCB, what
Electronics Forum | Wed Jul 18 07:30:18 EDT 2018 | ir11
Dear SMT Experts, Just want to seek for expert advice regarding Ceramic PCB. Our Customer want to run ceramic PCB and want to understand the challenges that we might encounter. Anyone have their experienced running or dealing with Ceramic PCB, what
Electronics Forum | Wed Jul 18 10:16:08 EDT 2018 | ir11
Thank you for your response and information. I don't have any idea on what is Hybrid Circuits but if I will use ceramic PCB does my current SMT line need to change which running FR4 PCB material? My apologized for my queries. Thank you. IR11
Electronics Forum | Tue Jul 24 17:29:37 EDT 2018 | action_101
Hello, If anybody has a TECI PJ1A programmer that they no longer need or know of someone that might have one lying around then please let me know. We are willing to pay top dollar for one of these older programmers. This specific programmer was used
Electronics Forum | Fri Jul 27 13:51:53 EDT 2018 | vlad_saviuk
Hi, have some question: during solder paste printing I'm faced with problems on the edge of the PCB - solder balls on gold pads. During analisys we checked everything - change squeegee preasure, different cleaning cycles, squeegee speed - no effect.