Electronics Forum | Mon Dec 21 10:20:47 EST 2009 | zanolli
We are looking to purchase a table top batch oven, with nitrogen, for prototype work on various PCB assy's - some with BGA's. The intent is to simulate a multi-zone production oven profile - and we kow that an exact simulation is not possible - just
Electronics Forum | Mon Jan 04 21:03:22 EST 2010 | cman
1) I'm not familiar with the acronym CAF. Could you spell that one out for me? 2)Why do you feel they need to be baked? Are they in a high humidity enviornment? the only time we bake is when we are dealing with moisture sensitive components. Do you b
Electronics Forum | Wed Dec 30 12:58:10 EST 2009 | vetteboy86
I'm setting up a matrix tray for the first time on our Quad QSP-2. I believe I have defined the tray and holder. Assigned part numbers. My issue is that instead of teach feeders, I think I need to teach table top. When I do this, I am not finding an
Electronics Forum | Wed Dec 30 14:51:50 EST 2009 | gantry
Craig - It has been quite a while but from what I remember you teach the tray holder in teach table top. Then you have to put the part/tray on the the tray holder. Also, ensure the part is in your program. I don't remember where to do that but I
Electronics Forum | Tue Mar 09 11:10:31 EST 2010 | baildl632
Graceyt, I know you are being shot a lot of info. Have you gotten any resolution to this problem? I've seen similar problems in our thermal chamber with Demodulation units. The IC, in the module, inside the radio inside the chamber at the top of ou
Electronics Forum | Wed Feb 10 01:53:04 EST 2010 | sparrow
Hello Glenn, thanks a lot for your response. The company I work for is launching LEDs production this year. We'll need to do a number of the environmental tests in our quality control laboratory. So the application for SAM and Xray systems is inspect
Electronics Forum | Mon Jan 25 17:13:53 EST 2010 | bing007
I am working on a vcd 8 with a problem of loosing the 5 volts supply. We have fitted a new supply that also provides the 15 volts. When we remove the connector on the power chassis for the 5 volts the power supply shows OK. When fitted the 5 volts is
Electronics Forum | Thu Feb 04 03:54:46 EST 2010 | mika
Hi, I know that I been out for this exact error message before (several years ago) and I am just thinking about it. It was something simple... Ok. When You say stops in the middle of placement phase; Do you mean in the first task block, have it alre
Electronics Forum | Tue Jan 26 09:33:24 EST 2010 | smt_guy
Hi, I have a copper plate that we received from supplier with oils and some sort of stains. We tried most of the general type of degreasers by soaking but didn't work until we tried a Floor Stripper from Ace and it does make the copper clean and shi
Electronics Forum | Tue Jan 26 10:26:54 EST 2010 | bandjwet
Dear SMTNetters: Based on your experiences is it really necessary to have today's YAG laser-fabricated stencils electropolished? I undertsand that this "requirement" is a carry-over from the days of CO2-fabricated lasers where the hole wall quality
