Electronics Forum | Thu Sep 22 18:47:08 EDT 2011 | rodrigo
Hi all, We just got this machine and it is not fully functional. I read somewhere here that the folder mint has some useful stuff. I run mint and it said that it cannot communicate with card 0,1,2,3 (x1,x2,x3,x4). It said to make sure the cards are
Electronics Forum | Mon Sep 26 12:58:33 EDT 2011 | action_101
So you are saying that building to class III is going to prevent failures? I disagree. Class III is trying to hit target condition in every aspect of the production of the circuit board. That my friend does not ensure failures from happening. I see
Electronics Forum | Thu Sep 29 19:11:47 EDT 2011 | swag
Now I see - not sure. The only trouble I've had that was similar was because an electronic eye on one of the stages was seeing a machine that was installed a couple inches over the top of the conveyor. We had to install a flat black plate on the ma
Electronics Forum | Tue Oct 04 11:54:49 EDT 2011 | davef
We'd like to help you, but we don't have a clue of what you're talking about. * Which 'heatseal' machine are you using? Is that a reflow soldering machine? See, we think of a heatsealing machine as one that bond the two sides of a plastic bag togethe
Electronics Forum | Fri Oct 07 14:05:50 EDT 2011 | unipertsmt
They must sell parts and support machines for 7 years after the date they last built it. The registation fee is on the edge. If you can find that they supported any customer and did not charge for it then you have a good case against them. The proble
Electronics Forum | Tue Oct 11 09:26:42 EDT 2011 | dilogic
For all of you that are using this version of GSM USOS, I've made a patch that changes default fiducial repair drop-down menu from "Reteach Fiducial" to "Alignment Done". We had a large batch of boards with lousy fiducials and it drove me crazy havin
Electronics Forum | Mon Oct 24 16:24:53 EDT 2011 | smdbert
Hello, My name is Bert i'm working by LéTÉ with two mydata smd machines and have sometimes several problems ,most of the problems try to solve it by myself but sometimes the boss also helps and i write the errors in map but first of all 4 questions
Electronics Forum | Fri Nov 04 22:03:35 EDT 2011 | machinehead
Yeah that is a drawback to those feeders. The > plastic part that is mentioned in one of the > responses is okay but you have to be real careful > when pulling the tape out before you can put that > part on. Mydata always says to leave the reel
Electronics Forum | Wed Dec 07 13:10:32 EST 2011 | conjugate
Hi Reese, the contamination is coming from the material of the PCB itself. Basically, there`re failure observed in the products from electronics factory. preliminary analysis been done, the main board not properly functioning due to bad solder. next
Electronics Forum | Fri Nov 04 13:24:30 EDT 2011 | tombstonesmt
Peelable masking has been our solution here recently. We an automovite customer that requires coating on both sides of the boards with many keep out areas. We are currently building a dispense robot that will apply tech spray wondermask 2218. The won