Electronics Forum | Wed Jan 23 17:14:33 EST 2002 | Shawn
We have seen solder joints that have an orange peel or textured appearance to them after running over our wave solder machine. We thought it may be disturbed solder joints but it does not have the lines or appearance that a disturbed joint usually sh
Electronics Forum | Tue Jan 31 11:57:40 EST 2006 | aj
i would agree with taking a closer look at the fiducials. I have the same line config. here but have to say that I have never experienced any conflict between machines. One thing I have seen before is when we ran a particular product on the machine
Electronics Forum | Tue May 02 14:30:07 EDT 2006 | finalassy
We have recently bought two new Pillarhose Jade selective soldering units. We are having a extremley hard time keeping the nozzels wetted while running the machine. I know that the nozzels are 99 percent iron. Has anybody ran into this problem, if
Electronics Forum | Fri Jan 02 10:12:10 EST 2009 | adamcrum
Yes, you are all helping me a lot. I have been doing research as well and although there is no requirement to have a certified tech, we do have to have the machine registered with the DoH as well as have a person trained in radiation saftey who has t
Electronics Forum | Thu Jul 05 16:41:40 EDT 2012 | stentech
It is very possible We do have lasers designed to cut upto 7feet long. However they are mainly backplanes.I would think this could be your issue although I still think them having the board would help. I am not sure where you are situated. If you wis
Electronics Forum | Wed Oct 25 16:23:08 EDT 2000 | JAX
If ya want info, I have to have a mailing address and an E-mail address.
Electronics Forum | Sat Dec 18 14:27:42 EST 1999 | g cronin
clarissa like in the other response if you have good technical support internally you can have good results with used equipment. We have run used chipshooters and pick and place equipment, but if we didn't have qualified personel internally to serv
Electronics Forum | Wed Feb 17 09:51:43 EST 1999 | Al
We have problems with solder balls after reflow. Anybody have any ideas as to what causes them?
Electronics Forum | Fri Oct 18 11:08:03 EDT 2002 | Bob Kondner
I like the MyData I have for high mix and prototype. Have not used the others.
Electronics Forum | Fri Oct 25 05:43:14 EDT 2002 | hanvictor
i have the experience like that, it should have something to do with solder paste.
