Electronics Forum | Thu Sep 24 12:18:38 EDT 2020 | tamasmagyar
I would recommend Grid-Lok from ASM, or VarioGrid from LTE. I have good experiences with them, and need small amount of maintenance in the long run. Both have magnetic bases and work with pressure air, but I've seen some models which don't require pr
Electronics Forum | Thu Oct 08 20:59:59 EDT 2020 | sosigguy
hello, have you solved this issue yet? can you not use the teaching function for a part to set the pickup position? I believe we have worked around by changing the property of one of the feeder types(i think we used Stick-B) under the machine proper
Electronics Forum | Fri Oct 02 11:02:24 EDT 2020 | proceng1
Do you preheat the board? Do you apply on two sides and let it fill under, or along all 4 sides? Does it bleed away from the part as well, or does it wick under the part during reflow? Basically, we've never used underfill before. So I don't know
Electronics Forum | Mon Oct 05 13:15:05 EDT 2020 | proceng1
I am trying to replace the anti-backlash nuts for the moveable rail on my ACCUFLEX Printer. I have parts diagrams, but none show the Y-axis width lead screw assembly. I can't figure out how to disassemble the screws to get the nuts out. Does som
Electronics Forum | Mon Oct 12 01:17:00 EDT 2020 | SMTA-64386317
Hi, I am facing high fall out of microphone low sensitivity issues. This microphone is soldering thru SMT soldering with low peak temperature profile which peak at 232 DegC to 240 DegC and have skipped X-Ray inspection but still seeing fall out espec
Electronics Forum | Wed Nov 11 03:36:10 EST 2020 | dekhead
Assuming you have defined HDD correctly (this is a non-standard CMOS setting), unless it is a totally dead HDD not the normal error for HDD failure. More inclined to think a CPU issue, I have not seen a "bad EEPROM" on that machine before... but pres
Electronics Forum | Thu Dec 10 12:12:40 EST 2020 | robl
Yep, done it previously with a multipot machine. Using with wirefeed to top up the pots means you only have a contamintion risk when you fit a new top up reel. Used separate nozzles for both, but theoretically using titanium nozzles would mean no c
Electronics Forum | Tue Jan 05 21:28:18 EST 2021 | rmitchell
We have an old MPM accuflex and both camera lights stopped working this morning during production. We tried the bulbs but the new ones did not work either. Any ideas on this? I don't think we have a manual but will keep looking in the dungeon. Plea
Electronics Forum | Wed Jan 06 22:10:04 EST 2021 | emeto
Measure if you have power where the light should go. Don't remember but it is probably 5V bulb/12V buld(it should say on it). if you have power, measure the bulb. I am not sure how new you new bulbs are.
Electronics Forum | Fri Feb 05 02:40:40 EST 2021 | victorzubashev
For components with the large pads, you can also use secondary soldering dispensing. Some printers like DEK have an option to mount a syringe with an auger valve to do dispensing after the printing step process. Obviously will not work if you have to
