Electronics Forum | Fri Jan 17 16:42:47 EST 2003 | MA/NY DDave
Gee this was a fun tread. I guess you mean Univeral Instrument Corporation's products. I would give them a call since they have a training center in Binghamton, NY and may have what you need. Trust me, They need the business and should jump all ov
Electronics Forum | Fri Jan 17 18:13:02 EST 2003 | MA/NY DDave
Hi I probably shouldn't say, Yet unless you are big or have some reoccuring kind of work with the government or ??, I wouldn't use the EMPF DaveF listed. They are now really the ACI (American Competitive Institute) and are not really the old EMPF
Electronics Forum | Wed Jan 15 11:42:57 EST 2003 | burb1999
we have recently been trying silver composition on our pads with our PCB boards. I am wondering what if any characteristics are different from tin etc... I have found with profiling the board it to be about the same temps. but getting granular looki
Electronics Forum | Fri Jan 24 22:22:26 EST 2003 | MA/NY DDave
Hi Entering just to keep this tread alive, and see more comments. Yes I have seen a serious decay over many years. In addition to the supplier side getting worse, incoming inspection, receiving seems to be getting worse. In addition to the decay
Electronics Forum | Fri Jan 17 12:50:14 EST 2003 | bpan
Support is ok but parts could be a problem...If you are buying an older machine you have to be careful because you may not be able to get parts.Tyco is still selling machines new and/or refurbed but there are lots of deals to be made elsewhere (used
Electronics Forum | Tue Jan 21 11:11:07 EST 2003 | slthomas
OK, so the issue is with the variability of the alloys on the soldering surfaces and the subsequent variability of reflow temps. Sounds reasonable (actually obvious, now that I think about it), especially on the component side. We only use HASL fin
Electronics Forum | Fri Jan 31 14:33:37 EST 2003 | joeherz
Dave, I do have the mechanical drawings but no electronic versions. After looking at the cost of setting up for N2 I decided against it for now, BTW. If you think about it, having an air knife on this nozzle would tend to negate the negative effec
Electronics Forum | Fri Jan 24 17:22:46 EST 2003 | cabjerk
Hi All; Does anyone have feedback on the reel/feeder storage retreival systems they have out there. We are looking at some different ones, but our shelving systems seem to do a better job. I concerned with downtime on these units and only one per
Electronics Forum | Wed Jan 29 18:27:25 EST 2003 | russ
That is one big melf!!! I do not even find this package size in any of my data bases. the largest i have ever dealt with is only .230 in. long. This one is .415 in. long? I would need to know the termination sizes also and then we can figure a pad
Electronics Forum | Fri Jan 31 05:18:10 EST 2003 | reg
We have a customer who is going to be using the new Snapshot process. Has anyone used this process all ready. Who did you use to make the tooling etc. Was there any problems that arose during this process. The process involves screening balls into s