Electronics Forum | Tue Oct 16 01:29:11 EDT 2012 | dman97
I have a very odd problem with my Fuji IP3 and was wondering if anyone can help. Any part that gets picked from the MTU will fail vision recognition. After turning on the vision trace data, I can see that the IP3 is looking for the part to be rotat
Electronics Forum | Mon Jan 21 07:01:02 EST 2013 | ericrr
I can not believe this, We get back from Summer holidays turn on the first machine Juki KE750L goes to do a home and before the head moves, Error notice: rear feeder rise error, I go around the back, nothing out of place. but notice the receiver end
Electronics Forum | Thu Feb 14 17:36:28 EST 2013 | dontfeedphils
I'm trying to get an '07 Accuflex into production and I seem to have a small problem. When trying to calibrate the zero pressure point on the squeegees I drive them down until they are touching the stencil and once they touch the stencil they run ou
Electronics Forum | Wed Feb 20 15:21:56 EST 2013 | rmitchell
Hi, hopefully I am too late, it is fixed and you are up and running. Have you tried MPM support on the phone? We have 2 older MPM's and the blow the driver modules in the bottom drawer on the back of the machine. There are different drivers for dif
Electronics Forum | Wed Feb 20 10:12:27 EST 2013 | dontfeedphils
Hey Bill, it really depends on the material you're looking at using UR, SR, AR, the easiest to deal with being AR, although if you can find a UR that doesn't clog up the machine too bad those are usually more viscous and easier to apply selectively u
Electronics Forum | Mon May 06 19:21:39 EDT 2013 | amelby
We had that problem on our M12. There were a few > components that had gotten dropped into the > camera area as the hydra head past over it. Our > MY12 has a knob towards the front of the machine > in direct line with the camera. Pulling this
Electronics Forum | Wed May 08 10:40:48 EDT 2013 | huske
We have had this problem before, and Phil was pretty close. On the hydra where the vacuum tubes are connected to the tools shafts you should see a red light inside there. this light locates a lazer cut mark on each of the tool shafts, this lets t
Electronics Forum | Fri May 17 08:43:46 EDT 2013 | fredcalkins
If you have Flexhead nozzles you need to be careful that whatever solvent you use does not attack the gasket adhesive. I might try a couple of drops of a spray like WD-40 or LPS. Let it soak for a few minutes and blow it out with compressed air. Repe
Electronics Forum | Fri Aug 30 05:34:28 EDT 2013 | bobpan
I would check the following: 1. Make sure the head can move in all axis including z and theta by physically moving each. 2. Check the voltage from the main power supply which is located in the middle of the machine on the top of the main board asse
Electronics Forum | Fri Aug 30 21:54:14 EDT 2013 | nophsem
Well, the error occurs with Mod Code 56 (dispenser enable). Head # 1 has installed this accessory, but we use it very little and it wasn't this time. I probed setting 0,1,2 and 3. I downloaded Mod Codes from controller to assembler, then the error b
