Electronics Forum | Thu Aug 18 05:07:53 EDT 2011 | johndoe0222
I received an error on my fuji ip3 which is: "Placing head 1 nozzle has become detached." Does anyone have any idea what is going on and how to fix this. Thanks
Electronics Forum | Thu Aug 18 12:46:43 EDT 2011 | jdengler
In the center of the head shaft there is a rod that is used to flag 2 sensors at the top of the shaft. This lets the machine know when a nozzle is attached. Check that the sensors are working correctly and the rod moves freely. The sensors are fib
Electronics Forum | Tue Oct 21 06:33:18 EDT 2008 | maheshbs
Dear stany, sry for wrong reply.
Electronics Forum | Wed Oct 22 13:39:38 EDT 2008 | evtimov
Did you check the lights? may be some leds burned there. Emil
Electronics Forum | Tue Oct 21 14:53:44 EDT 2008 | daxman
Hey, Are you having a problem with only 1 component from head 1 or all components on head 1? Thanks, Dax
Electronics Forum | Tue Oct 21 22:42:50 EDT 2008 | fujiphil
What error displayed after the vision process? If all the parts processed at Head 1 did not pass the vision, try to adjust the scan speed of the camera1. kindly send the error code. Jep
Electronics Forum | Thu Oct 23 00:43:30 EDT 2008 | stanyserrao
Light Units are replaced with new if the problem of lights then it will not vision process the nozzle center measrement and resolution Jigs too.. Jig is meauring in trace mode and identifiying all leads which are fine fitch. But a 1206 resistor is
Electronics Forum | Tue Oct 21 04:45:13 EDT 2008 | stanyserrao
Head 1 is not placing the parts in production. Same component is placed by head 2. Head 1 camera is camera 12 type and head 2 camera is type 8. Machine re-set done resent proper data and interchanged cameara still same problem was foundd in head 1.
Electronics Forum | Wed Oct 22 06:06:54 EDT 2008 | stanyserrao
1CA64011 and 1CAFE011 UsedBy Display 1CA??011 Cause The Vision_type in part data is expressed using hexadecimal notation ("??"). If "??" equals 1E, 64, 78, 79, AC, or FE then boundary detection could not begin because the nozzle was bent.
Electronics Forum | Mon Nov 10 23:20:55 EST 2008 | stanyserrao
Light Units are replaced with new if the problem > of lights then it will not vision process the > nozzle center measrement and resolution Jigs > too.. > > Jig is meauring in trace mode and > identifiying all leads which are fine > fitch. > >
winsouce.jpg)
.gif)
