Electronics Forum: heater panels (Page 1 of 2)

looking for heater panels for reflow oven.

Electronics Forum | Tue May 21 13:56:05 EDT 2013 | jayjjackson

I'm looking for heater panels ,4500W , 220/440V for our conceptronics reflow oven.

used vitronic reflow oven parts

Electronics Forum | Fri Jun 06 15:12:05 EDT 2008 | tomwho

Can anyone give me a contact for someone who sells used vitronic reflow oven parts. I am look for heater panels or heater wire for a vitronics smr-820 reflow oven,or some place that can replace the heater line in them. Thank you

Vitronics XPM1 problem

Electronics Forum | Wed Mar 13 06:37:24 EDT 2013 | jlawson

Not knowing XPM ovens , have zones are usually top heat and bottom, you replaced one heater panel-platten thus have a another above or below, maybe one above or below also is faulty causing heat spot on one side of oven ?

Vapour Phase

Electronics Forum | Wed Sep 05 13:45:36 EDT 2007 | john_smith

Ian, We currently have 2 inline vapor phase ovens and 1 batch oven. Tomb stoning is inherant with the Vapor phase systems but most can be stopped with a good profile. Most of our mechanical problems occur with the inline ovens during carrier transfer

Electrovert oven zone

Electronics Forum | Thu Feb 16 20:55:57 EST 2017 | youngbuck

Was wondering if anybody has experience a zone that will not get up to temperature. I changed the Solid state relay, made sure the thermocouple is working. The only thing I can think of is the bottom heater panel has a corroded/broken wire which is a

Vitronics XPM1 problem

Electronics Forum | Mon Mar 11 07:58:59 EDT 2013 | cyber_wolf

So I have this issue with my 1240. During my weekly oven surveyor check I get a software alarm that says I am out of tolerance. Probe #3 which is closest to the hinge side of the oven is approx. 10 degrees hotter in zone 12 than the other 2 probes o

Re: Reflow ovens : high mass vs. low mass

Electronics Forum | Tue May 18 14:47:02 EDT 1999 | Dave F

| Looking at the full convection reflow oven market, I see two segments, high mass heater ovens (i.e. Electrovert Omniflow,...), and low mass heater ovens (i.e. Heller,...) | Did some of you guys did some testing on both types and what were your find

BGA not level when placed

Electronics Forum | Tue Feb 26 10:27:12 EST 2008 | hegemon

We have both DRS24 and DRS25 here. I think you will be much happier with the DRS25 as the underboard heating is superior, of course after a year of using the 25, it has its caveats as well, though minimal. I was a little surprised that you are havin

Air Bath Rework System

Electronics Forum | Wed Dec 22 17:03:23 EST 2004 | jamesd

Shameless? In APE's experience not so - air velocity/power is extremely important in carrying energy to the board and close loop control of that energy is crytical in maintaining a controlled environment - if a machine design requires that air is for

Air Bath Rework System

Electronics Forum | Wed Dec 22 20:51:12 EST 2004 | Mark

Yes, shameless. You could have come out and said that APE's equipment is the best thing since sliced bread but . . . you had to get all scientific with us. We already get bombarded by subliminal messages in commercials now, tech forums. In all ser

  1 2 Next

heater panels searches for Companies, Equipment, Machines, Suppliers & Information