Electronics Forum | Sat Mar 06 09:50:38 EST 1999 | Dave F
A recent thread ... Pre-heat for Ceramic Capacitors - Igmar 10:21:55 03/04/1999 ... was addressing something that was discussed in an earlier thread. I searched 'til I was ARRRRRRHHHH! without finding the earlier thread. The weird part is: Search
Electronics Forum | Tue Dec 08 15:48:11 EST 1998 | John
| I HAVE SEEN ADVERTISED AN AIR NOZZEL THAT USES COMPESSED | AIR TO SPEW OUT EITHER HOT OR COLD AIR. I HAVE NEED OF | SUCH A DEVICE. I DO NOT HAVE THE MANFR. OF THESE. | ANY SUGGESTIONS ?? | Try Exair corporation. 1-800-exair is the phone #. I thin
Electronics Forum | Mon Nov 16 08:50:04 EST 1998 | Larry Johnson
I don't really no much of any problems other then, be sure that the BGA avoids moisture. If the BGA has moisture inside of it when it across the wave. Due to the heat, the moisture will evaporate and cause shorts inside the BGA. Now if someone can
Electronics Forum | Tue Sep 15 10:19:23 EDT 1998 | dave c
| Dave, | How thick are your PCBs? Do you have adequate topside preheat or are the bottom preheaters turned up to ensure proper filleting on the top side? | Rob Rob, The average PCB is .062". There is no topside preheaters on our machine
Electronics Forum | Thu Jun 25 14:33:51 EDT 1998 | Chry
| Hi there Chris! | Are the leads you talking about fine pitch? Is the complete fillet attached to the foot, with it being cleanly separated from the pad? I bet if you look at the board there will be via's really close to the pads at the location
Electronics Forum | Mon Jun 22 13:56:17 EDT 1998 | Upinder Singh
hi all. I am looking for a oven which can cure the conformal coating providing heat and the humid atmosphere. I am looking for a temperature range of 60 deg C to 80 deg C and a humidity range of around 80%. Can anybody refer to me the right vendors
Electronics Forum | Tue Jun 16 07:52:50 EDT 1998 | Jim Zanolli
| can any body help on assembling straddle mount connectors on to a board? for information on the connector - it is a berg micropak connector Teka Interconnection Systems (http://www.tekais.com)manufactures straddle mount connectors with solder and
Electronics Forum | Thu Jun 04 09:25:21 EDT 1998 | Chrys
| | | Hello: | | | BACKGROUD: SMT components soldered on the top-side of boards that also require wave soldering have the potential to reflow during wave soldering. Reflowing these components during wave soldering is not good. It can cause cold jo
Electronics Forum | Thu May 28 08:39:13 EDT 1998 | Rob Williams
I have a component that is glue cured on the bottom of a pcb. The component is a 1206 size jumper. It is made up of iron/nickel alloy. The problem I am having is that the part will fall off the board during wave solder. Is the component not able
Electronics Forum | Thu May 28 08:38:43 EDT 1998 | Rob Williams
I have a component that is glue cured on the bottom of a pcb. The component is a 1206 size jumper. It is made up of iron/nickel alloy. The problem I am having is that the part will fall off the board during wave solder. Is the component not able