Electronics Forum | Thu Dec 14 20:49:33 EST 2000 | Ian T
does anyone know if a 0402 can be placed by a FUJI CP3, i can pick them but the vision doesn't read it. any help would be appreciated. Ian T
Electronics Forum | Thu Dec 14 03:04:30 EST 2000 | Anuar Ahmad
Dear all, I wish somebody to help me to find any site that provide white paper about SMT and COB. Any information would be very much appreciated. Thank you.
Electronics Forum | Wed Dec 20 14:52:38 EST 2000 | susan
For attribute data, the process capability is reflected by the process average nonconforming (e.g.p bar). Reference the automotive group's AIAG SPC Manual. Hope this helps, Susan
Electronics Forum | Wed Dec 13 13:42:57 EST 2000 | Mike Ihm
The dielectic absorption characteristic of printed circuit board materials is usually not listed on the manufacturers spec. sheets. Can anyone point me in a direction to help determine which laminate materials might exhibit better dielectric absorpt
Electronics Forum | Fri Dec 08 14:03:52 EST 2000 | Roland
Andrea, There are many good sources for this info. One I suggest can be found at http://www.gii.co.jp/english/ab4031_yy_pcb.html. I hope this helps! Roland
Electronics Forum | Fri Dec 08 17:56:36 EST 2000 | Dave f
Check the fine SMTnet Archives. Some people have a difficult time using the fine Archives, if so, email me and I'll try to help further.
Electronics Forum | Mon Dec 11 12:46:02 EST 2000 | Christopher Lampron
We too had a problem with the WS609. We have since switched to Alpha's WS619 (same formula with an anti-foaming agent) This really helped but we still monitor flux application and try to minimize wherever possible. Chris
Electronics Forum | Thu Dec 07 09:26:05 EST 2000 | CAL
I do not work for SMTNET but this has been my experience from the past.........www.driveway.com is a site that you can up load images to and distribute the web address for all to veiw. Hope this helps Cal
Electronics Forum | Wed Dec 06 15:22:07 EST 2000 | Christopher Lampron
Does anyone know of documented inspection criteria for inspecting BGA's post reflow? (e.g. void percent, alignment, etc..) Any help would be greatly appreciated Thanks In Advance Chris
Electronics Forum | Tue Dec 05 08:39:22 EST 2000 | sean o'keeffe
i have a Staubli RX90 Cr robot on the back end of a small production line for automated systest and i need to source jaw grippers....any ideas where to look....... any help appreciated