Electronics Forum | Wed Sep 01 08:16:55 EDT 2010 | sachu_70
Drill holes or tooling holes have higher tolerances than Fiducial marks during PCB fabrication. I would certainly recommend Fiducial recognition as a more reliable approach for better accuracy. You could re-calibrate the Vision system file used for
Electronics Forum | Tue Aug 17 13:36:17 EDT 2010 | hegemon
Since you have home plated the apts and done solder reduction, I would take a look at your soldering profile. We have run into this before when running no-clean and found that reducing the initial ramp rate to the flux activation was a help in the
Electronics Forum | Thu Aug 19 10:28:26 EDT 2010 | tpearson
We want to complete an end of life build on a leaded no-clean circuit board assembly. I was asked how long the assembly can be stored for future use. Assume it is in a temperature controlled warehouse. Boards will be placed into individual ESD bags f
Electronics Forum | Sat Aug 21 15:02:32 EDT 2010 | jry74
I have a pcb with 750 plated through holes that get Holtite sockets inserted into them. I have a method of pressing in 10 sockets at a time. However, when we are done, the board has bad warpage on the X and Y axis. Does anyone out there have any t
Electronics Forum | Sat Aug 21 15:07:34 EDT 2010 | jry74
I have a problem with solder bridging between IC leads, especially fine pitch leads. If we lessen the apature ratio and/or decrease stencil thickness, I have more of a chance for unsoldered or insufficent joints. I am looking for any information th
Electronics Forum | Thu Aug 26 09:44:45 EDT 2010 | smtmfgeng
Hello all, I have a few CP43's and am struggling to find their air consumption ratings. I found that our IP3 consumes 240 Nl/min for the machine itself, and the MTU unit consumes 600 Nl/min, however Fuji's spec sheets do not list these ratings for t
Electronics Forum | Thu Sep 02 04:59:17 EDT 2010 | sachu_70
Feeder calibration helps to center the window opening used during component pick-up by a machine nozzle. Once this is established, the next step would be to confirm the centering of Machine nozzle to the center of this feeder window during machine op
Electronics Forum | Mon Aug 30 10:39:08 EDT 2010 | jamesc09
Is there any way to measure the copper oxide thickness on the inner layers of a PCB? I have been asked to investigate this and am not sure if it is possible. If it is, please tell me by what method, any contract labs that can do it, or the name of
Electronics Forum | Thu Sep 02 10:42:16 EDT 2010 | eezday
I spoke to a field service rep from Universal and he also suggested cycling the power on the machine. Unfortunately this didn't help me but I see a trend. I'm still open to any suggestion. I'm wondering, should I see a bright white light when the
Electronics Forum | Fri Sep 17 13:32:42 EDT 2010 | davidd1
AJ, I am the manager of Samtec's Interconnect Processing Group. The edge mount connector in question does present a set of unique assembly challenges but I am confident we can help you develop a process that fits your needs. Please contact our g