Electronics Forum | Tue Mar 07 11:04:58 EST 2006 | rlackey
We had 6's, 6-4000's, 6E's, & 6E-4000's. They we all the same to program, but from memory: the 4000's could handle larger boards (356x457mm?) & the E's had the Back/front key switch on the side of the monitor block, whereas the straight 6 had it on
Electronics Forum | Tue Mar 07 23:50:35 EST 2006 | karenp
Thanks guys ... you gave me some ideas, I'm trying to use the camera inspection in the gemini, I use it, but i don't have a "Golden dot" as you said Pete, i'm trying with DOE analysis.. I hope can get something good, and help the team with the missin
Electronics Forum | Wed Mar 08 16:52:07 EST 2006 | darby
Which model Yamhah are you talking about and what is the make and model # of the manifold block for the micro ejectors? If it has the Koganei ME05M series then your local rep can supply the filters. It is a good idea to get spare O-rings for the filt
Electronics Forum | Thu Mar 09 16:14:19 EST 2006 | marc
CGO Assuming your system is performing well here are a few ideas to help out your profile.... - Pull the material spec and ensure you are meeting the requirements for times and temp. Many times the material will allow a mild soak of the board prior
Electronics Forum | Tue Mar 14 15:13:35 EST 2006 | Kevin
The Novastar is primarily a low end machine made in India, I think. Technical Devices is more comparable with other dedicated wave soldering machine manufacturers. I recently got a good deal on a new TD machine with a Titanium Pot and Pump. It was
Electronics Forum | Tue Mar 14 14:25:15 EST 2006 | geb
Hi, I have a 1995 Universal GSM which won't zero its axis, so can't run. It crashed last night after displaying a "swapper.dat" file being full. I have restarted and checked the available space on the hard-drive - it has over 50% freespace. After st
Electronics Forum | Tue Mar 14 15:02:58 EST 2006 | bigdaddysoy9
You can try swapping cards 10 and 11 in your "General Purpose I/O Chassis", which is the front center panel of the machine. Make sure you change the jumper configurations before you swap them. If the interlocks start working, but your beacon lights q
Electronics Forum | Wed Mar 15 10:07:17 EST 2006 | geb
*** New related Question*** Thank you for your suggestions. Unfortunately it is still not working though. I have noticed at the top of the "General Purpose I/O Chassis" that a red LED next to PCB location 0 is permanently on. But this is not on on o
Electronics Forum | Wed Mar 15 04:32:14 EST 2006 | rlackey
Hi Brad, I don't know if this helps, but we had a policy of not accepting x-outs on rigids, and of max 10% per panel on Flexy boards (as long as the local fiducial was blacked out for the bad board) I'm always suspicious of x-outs as it points to pr
Electronics Forum | Wed Mar 15 21:21:43 EST 2006 | Chunks In Cebu
Yes, different pastes will cause ovens to become "dirty". I believe you are talking about flux build-up. I've switched from one paste to another based on sample studies, only to find an increase in oven cleaning. During most solder paste evaluatio
