Electronics Forum | Mon Jun 21 13:16:18 EDT 2021 | tomdegas
I just received the following messages while running our MY15: I-OSM-0: my15n150 kernel: lp: no devices found. I also received this one: I-OSM-0: my15n150 insmod: /lib/modules/2.2.20/misc/lp.o: init_module: Device or resource busy. And this one: I-
Electronics Forum | Thu Jun 24 07:50:36 EDT 2021 | ouaret
we have a Cyberoptics Flex ultra HR machine (model N 8010949). the alignment of camera 1,3,5 and 2,4 is impossible because the images from each Fire wire adapter don't have the same size. we tried to calibrate with the target board, but also unsucce
Electronics Forum | Sat Jul 03 19:17:49 EDT 2021 | oriolsancheza
Hello, We recently purchased two Orbotech Vantage S22 without any manual/guide for setup. So it's being quite difficult to make them work. We tried to contact orbotech but no luck, nobody replies. One of the machines hangs when starting Orpro First
Electronics Forum | Fri Jul 09 12:36:48 EDT 2021 | djenkins62
Great Question 1. Informal Testing with scales from Engineering Students at San Jose State. Report available upon request. 2. Internal Testing - Informal with scale 3. Visiting, Listening and Learning from SMTA Engineers...unfortunately, they wi
Electronics Forum | Fri Aug 06 14:01:53 EDT 2021 | tomdegas
Unfortunately all my tools are spring loaded. Yes I do know the tool install utility. I have been running and maintaining the 3 MyData machines for over 20 years and I never saw an error like this. I grease our tools once a month so I know that is
Electronics Forum | Wed Aug 11 06:27:07 EDT 2021 | danisa
Hi all, The PCBA was swollen after SMD It is hard PCBA with 6 layers and SMD both sides Defect rate: ~ 5% Phenomenon: swell at the same side, same position (at 2 IC positions). Did not find any abnormality in SMD process as well as storage condition.
Electronics Forum | Tue Aug 24 20:06:24 EDT 2021 | demradarmfg
I have mentioned this over 6 different support tickets (3 of which had no reply and were dedicated to this inquiry.) I have also called twice with no answer and no call back. I can try again but am definitely not impressed with them. The only respon
Electronics Forum | Sun Aug 29 12:29:37 EDT 2021 | jojoled
Hi, can anybody provide a Installation software for JUKI KE/FM760L,named as "Juki Flexible mounter 1.35 " or similar version? I need to change the PCB max.width limit from 410mm to 560mm(heads can travel that far, no problem) and on disk the MSDOS so
Electronics Forum | Tue Sep 14 13:01:11 EDT 2021 | jamesatqkits
Hi Bukas, Every head, yes they move down, I should have mentioned the sensor is on the right , not the left. It detects the mirror swinging down. There is another sensor on the servo motor, its mirror home, it works I see it changing when I break the
Electronics Forum | Mon Sep 27 01:23:29 EDT 2021 | sophyluo1985
Dear Boddy In fact, they are incomparable. But I personally recommend that you choose YS12F. Since you have a large number of yamaha old-fashioned feeders, I think you must be more familiar with the yamaha brand. And are there many QFN.LGA.BGA.TQFP e