Electronics Forum | Wed Jul 04 10:17:18 EDT 2012 | daxman
Good morning, Just a few questions to clarify: 1. You backed up your machine proper data. 2. You upgraded Fuji Flexa. 3. You re-transmitted the proper data 4. Now, components are not placing properly? Do you have a fuji 96-001 calibration board? Ha
Electronics Forum | Thu Jun 28 17:05:46 EDT 2012 | davef
Here’s what we seem to know: * There’s a problem with voiding in the solder connections of SMT capacitors * A void is an open area caused by air or process fluid that is trapped within a solder connection * Voids are an allowable condition as long as
Electronics Forum | Thu Jul 05 20:54:27 EDT 2012 | actioncontrols
Hello: We have used our Phillips Topaz on a number of volume jobs and been very pleased. A while ago it became apparent that the vision LED's were growing dimmer as evidenced by having to adjust light intensities upward for various components in so
Electronics Forum | Tue Jul 17 15:26:08 EDT 2012 | kruzer
Hi I use CP4, CP6, CP643, GLV and NXT, but i have a problem with CPIV, i cant use It with Director Fuji Flexa. i use snifer rs232 (rs232mon) to resolve problem and what i know: Computer send on rs232 to machine (every 1 min or something): vQN2105
Electronics Forum | Wed Aug 01 09:27:21 EDT 2012 | grics
I am looking to send a couple of employees to take some focused training in six sigma. It would more than likely be at the beginner level, overview to green belt. We are a smaller contract manufacturer and want to implement more use of six sigma me
Electronics Forum | Thu Aug 02 12:47:15 EDT 2012 | deanm
Even though I cannot answer your question about a good Six Sigma training course, our company has had training in lean which I felt was helpful. You stated that one of your goals was to reduce cost/waste. That goal seems to lend better to a lean ma
Electronics Forum | Mon Aug 06 14:44:07 EDT 2012 | joefosho
Hey guys, I'm new to this forum and registered to ask a question about PCB assembly cost. I was hoping to design a PCB that will be approximately 6" by 6" with about 1100 0805 SMD components on it. Half of them being resistors (3 different values) a
Electronics Forum | Mon Aug 13 12:38:38 EDT 2012 | grahamcooper22
Maybe the area ratio between the sides of the stencil apertures and the aperture opening is too low for the spec of the paste ? So it will tend to stick in the apertures. ...only solution is thinner stencil or a paste that can release easily when are
Electronics Forum | Mon Aug 27 08:22:39 EDT 2012 | rway
Dan_ems wrote, "I already build such a system with hardware and software from National Instruments. I think is the best solution because you can buy for the start only a Multimeter (DMM), a multiplexer and a software. Is very easy to do the programmi
Electronics Forum | Wed Aug 22 14:39:02 EDT 2012 | wendynguyen234
Our S-2000 pick & place machine has head 2 not picking up any nozzle & displays error code 8342(nozzle check error). In ANC setting, head 1 pick/put ok but not head 2; when "MANUAL" box is checked, clicking PICK/PUT then both head 1 & 2's status disp