Electronics Forum | Fri Apr 01 18:32:51 EDT 2011 | frcdave
Dback, Some questions for you: 1. Are you using the red light configuration for better contrast on the 0402 parts? 2. Is your system fitted with both low and High Magnification cameras? Have you spoken with the guys at YESTech? Their phone support i
Electronics Forum | Thu Dec 18 17:43:57 EST 2003 | JD
Good evening all, I have recently gotten rid of our old SRT rework station because of lack of use. Before dumping however I took the CCD camera and monitor in the hopes of turning it into a board inspection station. However, the camera and monitor
Electronics Forum | Tue Nov 08 21:56:23 EST 2011 | tpappano
Hi Jeff, both units have DC servos, and both appear to have the same vision system, although #2 has an additional upward-looking camera with a high magnification lens for die mounting. If I could make use of your hex files, that would be great sinc
Electronics Forum | Fri Apr 09 15:41:11 EDT 1999 | Matt Stackhouse
| DOES ANY ONE KNOW HOW I CAN STRAIGHTEN | BENT PINS ON A FINE PITCH QFP WITH OUT DAMAGING | THE CHIP. AT $300 A CHIP I CAN'T SCRAP THEM. Here is a neat trick if you have the equipment. If your company does any feature measurement of mechanical de
Electronics Forum | Wed May 10 12:13:16 EDT 2006 | scombs
We have a 6 up panel with a 1206 part .082" from the board scoreline. After depanelization when we run the board through ICT it fails for a short at that location. We have visually inspected at high magnification for any cracks in the body and at the
Electronics Forum | Sun Dec 11 22:55:22 EST 2016 | ppcbs
What type of flux is in your solder paste? Active or No-Clean? With lead free solder you really should be using an active flux. The lead free oxidizes during reflow if you are not using a Nitrogen or Vapor Phase reflow. So a more robust and activ
1 |