Electronics Forum: hit (Page 1 of 86)

Dek vista Camera hit the under screen when I went to stop position

Electronics Forum | Fri Oct 09 22:54:35 EDT 2020 | dekhead

Most likely cause is Servo AC drop.

Dek vista Camera hit the under screen when I went to stop position

Electronics Forum | Fri Oct 09 15:09:37 EDT 2020 | lesfarnacer

Hello everyone, need help please with my Dek vista, the camera hit the under screen when it went to stop position, I did the diagnostic and it did the same think only when it went to stop position . can someone help me with that please.

Dek vista Camera hit the under screen when I went to stop position

Electronics Forum | Fri Oct 09 23:40:44 EDT 2020 | lesfarnacer

can you explain me please what that means, I am not very familiar with term.

Dek vista Camera hit the under screen when I went to stop position

Electronics Forum | Sat Oct 10 01:21:00 EDT 2020 | dekhead

Please contact me directly, I would be pleased to assist you offline. DEKHEAD jrs-dek-tx@att.net

How to measure dimensions in gc prevue?

Electronics Forum | Wed Aug 05 08:16:34 EDT 2015 | emeto

Hi, that's how it works: 1. Zoom to the object you want to start with. 2. Click S to center to the object. Depending on the zoom you can center to pad, line, corner.... 3. Click Z(this zeroes your Relative coordinates). If you click Ctrl+z(this ze

Re: Popcorning

Electronics Forum | Mon Sep 11 20:24:45 EDT 2000 | Dave F

Gary: Consider using the SMTnet archives to get started: * Popcorn* gives over 70 hits * Moisture sens* gives over 115 hits There is some wonderful background information in the archives that oftimes serves as an excellent starting point when invest

Hits on minipage

Electronics Forum | Mon Jan 24 11:35:25 EST 2000 | SMTASSY

With the old revision of this site I used to see how many hits were done on our minipage. Is there a place where I can find this info on this new revision.

Cracked chip capacitors

Electronics Forum | Tue Feb 28 16:58:39 EST 2006 | PWH

Too fast heating/cooling rate in reflow (look at mfg's spec.). Z "overdrive" on pick and place or chipshooter though unlikely I would say. Depanelization method (bending a scored board to break it is tough on things). Bad PCB design - cap. too clo

Clearance between Through hole and chip component

Electronics Forum | Tue Feb 27 20:53:10 EST 2007 | davef

We'll guarantee the two pads are too close together. The proper spacing depends on the orientation of the parts to the wave. * Do the pads hit the wave at the same time? * Does one pad hit the wave before the other? If so, which? * How does the 06

Re: Digitizer help

Electronics Forum | Thu Jul 27 21:30:26 EDT 2000 | Dave F

Travis, I miss the point ... I can hit the spot on the board from 20 feet with those components!!!

  1 2 3 4 5 6 7 8 9 10 Next

hit searches for Companies, Equipment, Machines, Suppliers & Information

Blackfox IPC Training & Certification

Benchtop Fluid Dispenser
Global manufacturing solutions provider

Reflow Soldering 101 Training Course
convection smt reflow ovens

World's Best Reflow Oven Customizable for Unique Applications