Electronics Forum | Thu May 30 08:04:25 EDT 2002 | zanolli
Hello Russ, I'm not quite sure I understand your question. Are you saying that you must hand solder these connectors because the gold plating doesn't allow other though hole processing methods to wet the solder the length of the pin in the PTH? Reg
Electronics Forum | Tue Jun 04 13:13:58 EDT 2002 | slthomas
Another thing we see is solder balls (sometimes fines, sometimes larger stuff) in the vias after a misprint has been poorly cleaned, as in wiped down but not washed. They end up in the plated through holes too, but those get nicely cleaned up in the
Electronics Forum | Thu Jun 27 08:51:30 EDT 2002 | AOIgenius
You also need to take into consideration the print angle. Contact your screen printer manufacturer for specs.
Electronics Forum | Fri Jul 12 18:12:27 EDT 2002 | pjc
I used an Ebsomat 30-1 and had no problems with it. I counts thru-hole axial & radial and SMC on tape. go to http://www.ebso.com
Electronics Forum | Tue Jul 16 00:58:40 EDT 2002 | ppcbs
Anyone can suggest vendors that supply BGA to PGA adapters to adapt a BGA so that it can be installed on a throug-hole board?
Electronics Forum | Tue Jul 16 01:02:59 EDT 2002 | ppcbs
Can anyone suggest vendors that supply BGA to PGA adapters to adapt a BGA so that it can be installed on a throug-hole board? (http://www.smtnet.com/Forums/Index.cfm?CFApp
Electronics Forum | Wed Aug 28 19:35:13 EDT 2002 | ppwlee
Hi, Does anyone have guidelines on minimum SMT component spacing for bottom sided wave soldering? I am looking for general rule of thumb in wave soldering bottom side SOTs, 0805 & 0603s. How about minimum through-hole lead to pad distance? Peter
Electronics Forum | Wed Aug 28 19:36:29 EDT 2002 | ppwlee
Hi, Does anyone have guidelines on minimum SMT component spacing for bottom sided wave soldering? I am looking for general rule of thumb in wave soldering bottom side SOTs, 0805 & 0603s. How about minimum through-hole lead to pad distance? Peter
Electronics Forum | Tue Oct 22 10:47:13 EDT 2002 | voyager
Have you looked at TDK's VC series? The newer vintage models are gems (VC7's, etc), but hard to find. Good Luck.
Electronics Forum | Tue Oct 22 20:13:12 EDT 2002 | Charlie
We are looking at using STH in our no clean and aqueous processes. Can you comment on any special issues we may need to consider? Also any link to papers or articles would be helpful. Thank you.