Electronics Forum | Mon Oct 23 15:03:19 EDT 2023 | davemccabs
Hi everyone, We just acquired a MPM Ultraprint 1500 and dont have manuals for it. It's running SigmaPro 32 v6.3 software. Would anyone please be able to share any manuals for it? Hopefully more than just the operator manual. Thank you!
Electronics Forum | Thu Feb 15 18:35:10 EST 2024 | prestonames
Hi Mahmoud, I hope you were able to find a solution for your project! My company recently purchased an ASM Eagle Xtreme Gold Wire Bonder and we have been unable to locate the manual. Is it possible to share the manual that you have over email? Pleas
Electronics Forum | Thu Mar 28 15:18:21 EDT 2024 | tey422
From the error message, might have to do with the "Z"-axis. You didn't mention you redo the calibration or not, then you should run that too. My guess would be "Z reading maybe slightly off". BTW, last time I work with those Mydata machine were bac
Electronics Forum | Fri Apr 27 13:35:46 EDT 2007 | sjpence
I do not know of any standard recommended values for impact pressure in cleaning equipment. They act more as a guide when examining the various choices manufacturers have made for the spray flow, nozzle pressure, nozzle spray angle and other factors.
Electronics Forum | Wed Feb 22 03:29:09 EST 2017 | niki
Which is the best way to clean the PCB after > soldering? Is it good enough with IPA > (isopropyl) or with the Flux Remover > spray? However, we use a lead free solder wire > (3,5% flux inside the core) and after the > soldering its a visible we
Electronics Forum | Wed May 15 16:07:23 EDT 2013 | rgduval
We've recently acquired a Rayco Aqua Blaster 1250 from an equipment auction. As with a lot of used equipment, it did not come with a manual or documentation. I've finally got a DI system hooked up, and am working on getting the washer going. But,
Electronics Forum | Mon Feb 21 11:22:21 EST 2000 | K. Ckak
Hi Kurt, I agree with Dave F. I had exact same problem with PBGA placement. We requested our PCB vendor to plug/tent via (button printing) after HASL with SR1000 which worked well in the long run. There are couple of failure modes associated wit
Electronics Forum | Wed Feb 16 05:09:30 EST 2000 | Dean
You might try a no HASL spec on your fids...but shelf life may hamper copper quality. Not a pleasant situation...opertors tend to polish the fids with erasers to compensate but this leads to eraser "bits" in your equipment and your solder! Maby op
Electronics Forum | Fri Feb 11 11:09:40 EST 2000 | John
I'm new to this site and hope to get some information. I'm probably going to get a ton of junk mail, but here goes. We are in the process of evaluating new equipment with the eventual outcome of installing a complete SMT line. We are not a high vol
Electronics Forum | Wed Feb 09 19:55:27 EST 2000 | Russ
Hello All! I have a problem that hopefully someone out there might have some ideas. I have an assembly that upon the "dental pick test" the entire solder fillet is coming up with the lead and leaving what appears to be a bare pad. I believe that th