Electronics Forum | Fri Mar 26 06:58:06 EDT 2010 | ristikas
Hello, We have here very oftenly one error in our MPM Accuflex. I dont know who to ask about that errors... The error is „The transfer light peam interlock has been broken. Remove the obstacle from the path of the beam.“ I checked the sensors and
Electronics Forum | Tue Mar 30 05:27:06 EDT 2010 | accuspares
Hi, Can you tell me at what point in the print cycle the error happens and if it consistently happens at the same point? The machine has two crash beams running down either side of the machine as a safety measure to ensure the table is down before
Electronics Forum | Tue Mar 30 06:27:22 EDT 2010 | ristikas
It happens on the middle of the stecil cleaning. The camera and the cleaner will stay under stencil in half way back. Then machine asking the initate the motors. If to press initate then the pcb stopper will hit the rails. Usually we move camera and
Electronics Forum | Wed Mar 31 04:43:52 EDT 2010 | accuspares
If you dissconnect the crash beam sensor one at a time at the front leaving the remaining one connected you’ll be able to identify what side is causing the problem. Then you will be able to hopefully remove the object or adjust the position of the be
Electronics Forum | Wed Aug 04 18:12:27 EDT 2021 | tomdegas
I am trying to install an A12 tool on my MY15 and I get the following error: "F-TLMN-9: Failed preliminary fetch during installation" I looked it up and it says Operator error and that the tool is missing. The tool is in the tray and the MY15 picks
Electronics Forum | Thu Aug 05 17:23:22 EDT 2021 | tomdegas
I just tried and I am getting the same error for all the tools.
Electronics Forum | Thu Aug 05 17:37:28 EDT 2021 | SMTA-64387687
Did you grease the tool o-rings? If they are too dry, the head won't slide onto the tool. Also, make sure the tools are flat in the tray. I'm assuming that you aligned on the center of the tool. And, try cycling the non-spring tools, like A24, to see
Electronics Forum | Fri Aug 06 17:19:46 EDT 2021 | SMTA-64387687
It seems to me that something is out of calibration. I noticed that you were reinstalling TPSys. Did this start after the reinstall? Did you restore a backup of your parameters, or recalibrate the machine with new values? Try changing the tools to "n
Electronics Forum | Fri Aug 06 14:01:53 EDT 2021 | tomdegas
Unfortunately all my tools are spring loaded. Yes I do know the tool install utility. I have been running and maintaining the 3 MyData machines for over 20 years and I never saw an error like this. I grease our tools once a month so I know that is
Electronics Forum | Thu Aug 05 15:06:02 EDT 2021 | tey422
The last time I work on the Mydata machine was like over 15years ago. Sorry, I couldn't provide much more help than what I could remember so far.
