Electronics Forum | Fri May 09 14:56:37 EDT 2008 | markhoch
The paste dispensers work well as long as the humidity in your shop is properly controlled. If it gets too humid, and the paste gets "soupy", then it will take less air pressure to dispense it onto the stencil. Paste dispensers use a controlled, pre-
Electronics Forum | Wed Dec 09 13:25:16 EST 1998 | Martin J. Ibarra
Hi, I know for sure that by controlling temp. and humidity conditions in SMT assy lines room, one gets advantage in screen printing, adhesive dispensing, and pick&place machines mainteinance. Does any one have any advice on why else is a clean room
Electronics Forum | Tue Mar 09 23:34:35 EST 1999 | Clarissa Ortner
We are starting up an SMT line with a printer and convection oven.... The area we are considering for the printer is totally uncontrolled for humidity, temperature and even cleanliness. We are working on the filters to keep particulates down, but I
Electronics Forum | Wed Dec 09 15:54:05 EST 1998 | Dave F
| Hi, I know for sure that by controlling temp. and humidity | conditions in SMT assy lines room, one gets advantage in | screen printing, adhesive dispensing, and pick&place | machines mainteinance. Does any one have any advice on why | else is a c
Electronics Forum | Wed Sep 24 09:53:25 EDT 2014 | rgduval
For me, it would depend on a couple of things: 1. How many parts are stored in this manner on a regular basis? 2. Was the oven used for anything else other than this type of storage? If it was a low volume of parts, and the oven wasn't used for
Electronics Forum | Tue Aug 14 08:44:44 EDT 2012 | ducati
HI, we use the SMT Tower software to controll it. The Tower is afully automated storage which controlls the humidity. Is a component leaving the Tower, the time is runnig. Is the Component back in the Tower, the time is stopped.
Electronics Forum | Thu Jul 19 08:00:03 EDT 2001 | doctord
Solder balls or mid chip beads? Remember IPC classification for Class 2 allows mid chip beads encapsulated in flux. Usually on R's and C's first thing I would do is verify .006 laser stencil 10% reduction and the most critical, The paste must be on t
Electronics Forum | Tue Jul 25 09:42:52 EDT 2006 | razor9114
Good morning, I got a question regarding Immersion Silver Board Finish. It has been imposed on us by our customer that we must manufacture PCB through the SMT process within 24 hours of breaking the seal on a bag of PCB containing Immersion Silver.
Electronics Forum | Thu Jul 01 15:12:16 EDT 2010 | siddharth
Thanks to all for their inputs. @Hexielectronics, I am now trying to assemble the board by attaching it to a frame and removing the frame while waving it. I plan to put the boards back on the frame after the board cools down. Could you explain more
Electronics Forum | Thu Dec 16 04:14:16 EST 2010 | kemasta
Hi, I am new in this industrial. I learnt that PCB may absorb moisture and eventually caused delaminate after heat apply on it (reflow or wave). But I don't quite understand, if the PCB was keep in sealed bubble bag, and with the humidity control wit