Electronics Forum | Tue Feb 24 06:44:50 EST 2015 | bugarin
Hello , We are using Kester 959T flux and we wish to purchase Aim Ws 716 flux, due to higher activity. We also use humiseal 1a33 for conformal coating. Is anyone using Aim flux and humiseal 1A33, are they compatible ? Thank you for info
Electronics Forum | Tue Jul 05 15:26:10 EDT 2005 | jimih280
Where is the best place to buy Humiseal 1A33 in gallons?
Electronics Forum | Thu Oct 01 07:03:55 EDT 2009 | davef
We doubt that Humiseal 1A33 is causing opens in your assemblies. We'd guess the opens occur earlier in the process, but are not hard failures. So, you pass your tests. When applied, the conformal coat flows into the gap in the ball crack and insulate
Electronics Forum | Fri Aug 07 16:45:35 EDT 2020 | duso02
All URs require a long time to fully cure. And actually, most users do not reach full-cure before using the board. Even Humiseal 1A33 will be dry enough to handle after a very short time.
Electronics Forum | Thu Oct 01 03:03:29 EDT 2009 | cunningham
what we are getting is open circuits not every BGA is failing we use Humiseal 1A33 and currently there is no masking instruction for around the BGA
Electronics Forum | Sat Aug 07 02:28:20 EDT 2010 | raghu
We have PVA 350 benchtop dispensing equipement with humiseal 1A33 CC material. is there any moisture measurement process in conformal coating material?
Electronics Forum | Mon Jan 28 11:50:23 EST 2013 | johng
Good morning Mark, No issues around the masking at this point. The issue seem to be in open areas as well as between clad runs. We are using Humiseal 1A33 Conformal Coat.
Electronics Forum | Tue Nov 26 18:41:14 EST 2013 | triciawmcgough
Dear Mike, I've forwarded your question to the experts at Nordson ASYMTEK. I believe most of the team are on leave for the holidays, but hopefully we'll have an answer for you next week. Thanks!
Electronics Forum | Thu Dec 05 02:22:29 EST 2013 | mg2013
Hi Tricia, thanks a lot for your help, i will contact Nordson Asymtek immediately! Greetings Michael
Electronics Forum | Wed Feb 25 01:58:48 EST 2015 | bugarin
Sorry , I`ve got the wrong flux code ,we use NC Kester 959T and we intend to use NC277 VOC-free from AIM, Cheers