Electronics Forum: hydra (Page 1 of 16)

tp9-4 problem with hydra camera

Electronics Forum | Mon May 31 11:08:28 EDT 2010 | padawanlinuxero

Hello I am having problems with the hydra camera, I start getting an error message saying that the camera couldnt look at the fiducials on the hydra, I went to the camera in service and turn it on to see the problem but I found out that the real pr

MY9 Hydra errors

Electronics Forum | Wed May 13 15:57:43 EDT 2020 | azdback

We have been working on an intermittent error on our hydra. And it seems to happen only after several hours of production have passed, it doesn't happen during the first part of the shift. Our hydra goes from working fine for several hrs to making

MYDATA - how to forse parts on Hydra head

Electronics Forum | Mon Jan 02 09:39:34 EST 2017 | dyoungquist

I do not know the limit for component height on Hydra.

Mydata Hydra and 0201 components

Electronics Forum | Fri Sep 02 10:14:18 EDT 2005 | Mity-C

Hi, We have done many 0402's with Hydra. We have done 0201's with the single head on Linescan but have yet to actually run them on Hydra. We now have a machine equipped to do this with the corresponding hydra tips. I will update as soon as I have an

MYDATA - how to forse parts on Hydra head

Electronics Forum | Mon Dec 19 07:55:30 EST 2016 | bk

I am assuming that these are the round aluminum electrolytic caps. The problem may be that they are too wide to put on 2 hydra heads next to each other. Plus the hydra heads are not that great at placing tall parts. I would not let the hydra place th

Mydata Hydra....Did you know........?

Electronics Forum | Tue Aug 09 08:22:04 EDT 2005 | cyber_wolf

Did you know that if you break a tool shaft on your Hydra 2D head, you need to replace the entire Hydra head ?

MYDATA HYDRA Z/156 error on Hardware Intialization.

Electronics Forum | Tue Mar 03 13:40:44 EST 2020 | tomdegas

I swapped out the cable with no luck. The Hydra Z controller is the board on the right side of the Hydra head with everything plugged into it right?

Mydata Hydra tool reference marks error

Electronics Forum | Wed Jun 17 01:02:16 EDT 2015 | armandogomez

Hello Had a similar problem way back with the hydra, first go to the service program manually activate the hydra camera then move the Xwagon to place the hydra ref plate over the hydra camera and check first if the camera works, second the image you

Mydata Hydra tool reference mark error

Electronics Forum | Wed May 08 10:40:48 EDT 2013 | huske

We have had this problem before, and Phil was pretty close. On the hydra where the vacuum tubes are connected to the tools shafts you should see a red light inside there. this light locates a lazer cut mark on each of the tool shafts, this lets t

MYDATA HYDRA Z/156 error on Hardware Intialization.

Electronics Forum | Wed Mar 04 12:51:41 EST 2020 | bk

That error means your hydra z did not reach it's specified position. With the machine on you should be able to manually push the hydra down and let it come back up. Make sure it isn't being held up or hitting anything as goes down. Lots of times a pa

  1 2 3 4 5 6 7 8 9 10 Next

hydra searches for Companies, Equipment, Machines, Suppliers & Information