Electronics Forum | Tue Nov 06 07:37:02 EST 2007 | cyber_wolf
Does anyone out there have a method of cleaning CP6 shaft clutches that is "easier" ? I am not a fan of just pulling the shaft down and wiping it out. I like to take them apart and clean/lube them. It is a pain to get the crowns back on without rip
Electronics Forum | Wed May 08 10:40:48 EDT 2013 | huske
We have had this problem before, and Phil was pretty close. On the hydra where the vacuum tubes are connected to the tools shafts you should see a red light inside there. this light locates a lazer cut mark on each of the tool shafts, this lets t
Electronics Forum | Wed Feb 13 12:24:26 EST 2019 | aldrich17
Does anyone happen know where i can find an R alignment tool? Part number 5322 395 10879. Also a disassemble shaft tool. Part number 5322 395 10877
Electronics Forum | Thu Jul 19 04:23:38 EDT 2007 | chrispy1963
You dont mention if it is ONLY occuring with the A12 or is it other tools as well? Only spring tools or Stiff ones? Regardless of that, the small X Wagon motor is controlled by the track ball and the bigger X Axis motor is controlled by the joystic
Electronics Forum | Wed Jun 17 01:02:16 EDT 2015 | armandogomez
Hello Had a similar problem way back with the hydra, first go to the service program manually activate the hydra camera then move the Xwagon to place the hydra ref plate over the hydra camera and check first if the camera works, second the image you
Electronics Forum | Sat May 04 11:24:08 EDT 2013 | amelby
Hi, I have been having a problem with my My19E's hydra. The machine comes up with an error "Failed to locate HYDRA tool reference marks" and stops running. It does not happen for about the first two hours of running. It starts to happen after that an
Electronics Forum | Wed May 08 11:20:24 EDT 2013 | amelby
Thanks for the info on the Hydra tubes that will be helpful. I found the answer from one of the Mydata techs. The Camera needs the hydra head to go slower then 1.9m/sec and the setting was at 1.8m/sec. They found out that even if the machine was set
Electronics Forum | Tue May 07 09:20:43 EDT 2013 | dontfeedphils
That may have fixed it, but it doesn't sound like that would be the original cause.
Electronics Forum | Mon Jun 15 17:54:38 EDT 2015 | catsem23
Hi I have been having a problem with my Hydra tool reference plate. Machine keeps stopping and comes up with error message - failed to locate hydra tool reference marks & Error mounting component .... from feeder ..... with nozzle .... I have check
Electronics Forum | Sat May 04 14:36:53 EDT 2013 | dontfeedphils
It's been a while since I've used a MyData but I believe what happens is on the bottom of the hydra black metal piece is a mark that the vision system uses to locate the tools as they pass over to center the parts. Something may have happened to this
