Electronics Forum | Wed Jul 17 14:13:08 EDT 2013 | kenkay
We have an ICOM 6000 rose tester and everytime we run a program the machine stops and says "resistivity error". We have changed filters and calibrated the solution with no luck. Any ideas?
Electronics Forum | Fri Jul 26 12:46:30 EDT 2013 | gallionc
I am not familiar with the ICOM 6000, but we have an ICOM 5000. It could be possible that your Resistivty probe is bad, or possibly disconnected? We've also had different errors that were simply caused by not having enough solution in the tank. J
Electronics Forum | Wed Jul 31 11:31:54 EDT 2013 | pbarton
Could it be that the IPA you are using in the solvent/DI mix is not anhydrous, or in some other way not the correct purity? If it is not correct you will not be able to calibrate. Best rgds, Peter B.
Electronics Forum | Wed Jul 10 08:50:02 EDT 2013 | mobe1969
Hi SMTnet Members I'm looking for some help with my Westek ICOM500 Ionic tester. It has been sitting for a while. We want to get it up and running. I don't have any tools with this tester. Do you know what material I need to get this to work? Calibra
Electronics Forum | Thu Nov 04 19:51:28 EST 1999 | John
Thanks folks. The current vendor is doing an alcohol wash, top and bottom, then performing an ionic test on 100 boards. I'm not to confident in the testing because the readings for a "clean" board are 25 ugm/sq in and a "dirty" board are 40 ugm/sq in
Electronics Forum | Thu Mar 31 23:14:18 EST 2005 | Steve
Russ if your asking me if covering the surface of the granite defeats the purpose then I'm lost. An ionizer is a very good suggestion but they are not inexpensive. If the table is grounded and the metal bars are on a grounded mat, laminate etc. then
Electronics Forum | Thu Feb 22 10:32:25 EST 2001 | CAL
SCOTT- We do solderability testing for the electronics industry using a Multicore and Kester Wetting Balance testers. The standards we test to is IPC J-STD 002 for components and J-STD 003 for PCBs. There is also a system called SERA we co-developed
Electronics Forum | Thu Dec 28 14:50:56 EST 2017 | stephendo
Leather is not very insulative. AFAIK a lot of good quality dress shoes are naturally ESD safe. (or maybe test too low.) Check the dress shoes with a tester. And I'm guessing that stapling the straps is out of the question.
Electronics Forum | Tue Mar 07 21:35:16 EST 2006 | Cal Kolokoy
Samir, From experience, the only board test situation where tented via's have difficulty with contact is with a Flying Probe type tester. Otherwise, for traditional ICT, the force of the pogo pins, correct probe type, and fixture design should do th
Electronics Forum | Tue Jun 09 17:30:44 EDT 1998 | Yuan
If i want to set up an assembly line, what would be the approximate cost for testers? Appreciate any replies. Yuan
