Electronics Forum: ideal tension (Page 1 of 1)

Surface Tension vs Part Mass

Electronics Forum | Wed Sep 13 10:49:07 EDT 2006 | slthomas

1/4-20 would be unlikely to fit on an 0603 is all. I have to admit that when he first brought up the hardware theme I kept visualizing a jack screw assembly but the results I envisioned were less than ideal.

Yield on 0402 SMT Printed Circuit Board Assemblies

Electronics Forum | Wed Jan 10 20:06:43 EST 2007 | SSS

I've been assembling thousands of boards for dozens of customers over the past 5 years with 0402 chip components. 85% can happen very easily even with newer equipment. Defect challanges with 0402 packages is almost always tombstoning. Capacitors abou

Wave Soldering Process Restrictions

Electronics Forum | Wed Feb 21 08:48:37 EST 2007 | rgduval

Ideally? Never. You risk component break down by re-running the board over the wave machine. In a perfect world, your wave operator would make adjustments after one run, and you'd run another panel over the wave to judge the effectiveness of the a

Re: Closer lead more soldering bridge by using spray flux

Electronics Forum | Tue Jun 08 17:52:53 EDT 1999 | Chrys Shea

Hi,my master How to iron out such soldering bridge with below conditions: 1.The component(Harness)lead pitch is 2.0mm,the lead length is 3.2mm. 2.PCB width is 1.6mm.Pad size is 1.65mm.Its a single copper PCB 3.using s

  1  

ideal tension searches for Companies, Equipment, Machines, Suppliers & Information