Electronics Forum | Wed Apr 16 19:23:52 EDT 2008 | molos21
I think you are close to the problem when you expect the pcb having a problem. When I look at your different pics I saw that your via holes looks like this pcb has a hasl finish... and when i look at Q 14 this picture tells me that the pcb is not an
Electronics Forum | Wed May 21 09:03:52 EDT 2008 | bing007
I have been confronted with a MPM with a rheometric pump head on and have not had much to do with these. It is giving varying results on the down line paste AOI and is not responding very much to changes in pressure, speed etc. It is a 16inch pump, w
Electronics Forum | Tue Nov 25 05:40:52 EST 2008 | wanderson
Calibration menu and then Index Cam Setup and follow the on screen instructions. (You can skip the focus step if you have not adjusted the camera's) The point you need to pay particular attention to is when it displays the intensity histogram, this
Electronics Forum | Sat Nov 29 13:17:24 EST 2008 | exman
ASSEMBLEON AX-5 ax-5 having problem with pickup problem when the head placement try to pickup the component on the feeder the toolbit will fall off eventdo teach the part center very good but when they pickup it off about one inch happent on ly robot
Electronics Forum | Tue Mar 17 07:32:10 EDT 2009 | davef
Solder ball acceptance: IPC-A-610, 6.5.3.1 & 12.4.10. Solder balls: 5 ball system: * No more than 5 balls per square inch (100mm2) allowed * Solder balls can not be greater than 5 mil (0.005in) (100um) * Solder balls cannot be less than 5 mil (100um)
Electronics Forum | Mon Jul 13 09:34:32 EDT 2009 | csm
Dear all, we have an Fuji CP6-4000 we get some weeks ago, but it shows an error "Hardward NG and show some actions (Inch the axis to cancel the overtravel. Then switch the power off and restart the machine). We did but display same error. I would
Electronics Forum | Mon Jul 13 10:04:06 EDT 2009 | csm
Dear all, we have an Fuji CP6-4000 we get some weeks ago, but it shows an error "Hardward NG and show some actions (Inch the axis to cancel the overtravel. Then switch the power off and restart the machine). We did but display same error. I would li
Electronics Forum | Sat Feb 27 20:06:13 EST 2010 | jmelson
Oh, the CSM only has one XY offset for each feeder rail. If you don't like it, you can teach any particular feeder location. The crazy thing is the teach camera is an inch in front of the heads (-25 mm Y) so you can't put the teach camera over the
Electronics Forum | Wed Feb 10 16:51:01 EST 2010 | flipit
Anyone using ENEPIG electroless nickel electroless palladium immersion gold? Am currently using selectively plated gold 25 micro inches in combo SMT/COB gold ball bonded product. Gold cost has increased over the years. Palladium cost is much lower
Electronics Forum | Fri Dec 10 02:40:07 EST 2010 | tpappano
Hi Jeff, There is a visible roughness in the groove in the front most six to eight inches of the screw, and this is where some noise is produced when operating. I called Assembleon once looking for another part, and they flatly offered no support a