Electronics Forum | Fri Nov 05 22:45:04 EDT 2010 | wingding
Does anyone know where to but parts for Hover Davis feeders. I need a 18 ½ x 1/8 inch drive belt for a Fuji feeder.
Electronics Forum | Sat Dec 17 13:58:25 EST 2005 | bvdb
Jared, Thank you for the help. AFter following your advice we were able to get the display to say Jog L. However, pressing the UP or DOWN arrow or pressing the "F" key and the UP or DOWN arrow didn't do anything. The trays stay put. When we requ
Electronics Forum | Thu Sep 16 18:25:22 EDT 2010 | slwolbert
Thanks for the response Travis. I'd think the table would inch or move if it were stuck inching keys. The table would eventually trigger one of the overtravel sensors on this ancient machine. Much Appreciated, Steve
Electronics Forum | Mon Oct 01 14:42:18 EDT 2001 | Doug Sanders
Dan, Fuji has the NP XL series that will allow 27 by 23 inche boards using a conveyor.
Electronics Forum | Tue Sep 14 17:10:08 EDT 2010 | travishemen
I would check for stuck inching keys.
Electronics Forum | Thu Dec 15 01:21:42 EST 2005 | bvdb
We own a Fuji IP1 with all the manuals, etc. but can't figure out how to inch the tray robot. We can inch the X, Y, Z, Q axis and the SX and SY axis. All the axis auto zero OK (including the trays), but when I push the "4" key to inch the trays we
Electronics Forum | Mon Apr 09 10:16:14 EDT 2007 | davef
Pick and place: * Fuji: The largest pcb size is 20" by 18" for pick and place; 18"x14" for chip shooters. Fuji NP XL series allows 27 by 23 inch boards using a conveyor. * MYDATA has machines that can be configured to 34" X 44" X 0.500" * HSP 4796A a
Electronics Forum | Mon Jul 13 09:34:32 EDT 2009 | csm
Dear all, we have an Fuji CP6-4000 we get some weeks ago, but it shows an error "Hardward NG and show some actions (Inch the axis to cancel the overtravel. Then switch the power off and restart the machine). We did but display same error. I would
Electronics Forum | Mon Jul 13 10:04:06 EDT 2009 | csm
Dear all, we have an Fuji CP6-4000 we get some weeks ago, but it shows an error "Hardward NG and show some actions (Inch the axis to cancel the overtravel. Then switch the power off and restart the machine). We did but display same error. I would li
Electronics Forum | Mon Mar 22 00:13:06 EST 2004 | D. Sanders
Alan, Just so you have something to compare with, Fuji also carries a solution for your current issue. It allows them to place tape parts on a fixture that allows you to fit up to 20 different parts in the tray tower. It looks like a std. JEDEC tray
winsouce.jpg)
