Electronics Forum | Wed May 25 19:11:49 EDT 2005 | jsloot
That I can do, checking the placement height that is and the clamps. I believe my clamps are 4mm. If your nozzles have survived 5 years how many placements is that...roughly? In the billions?
Electronics Forum | Tue Jun 07 12:34:24 EDT 2005 | bradlanger
We have a CP-40 and a CP-50 and have placed millions of 1206 parts in the last year and there is minimal wear on the N08 nozzles.
Electronics Forum | Wed May 25 15:40:27 EDT 2005 | james
Has anyone had good luck with the reflow on these extremely heavy bga's. This bga has 1517 balls and requires alot of heat because of the thickness of the part. Just wondering if anyone out there can help me.
Electronics Forum | Thu May 26 10:47:28 EDT 2005 | james
What is the highest temperature set at in your oven and your belt speed. Also what type of oven do you have? Thanks much. Your right about alot of heat needed. We actually see the outside balls much flatter and soldered compared to the middle bal
Electronics Forum | Thu May 26 21:07:22 EDT 2005 | KEN
This is caused by cte mis-match. The balls in the corners are short and fat. The balls near the null point are tall and more normalized. I don't remember what the zone settings were... BTU VIP98 BS was probably 22-25 IPM
Electronics Forum | Wed May 25 21:56:06 EDT 2005 | dougt
I would think the communication between the machine and feeder would be the main drawback, not sure if the manufacturer will give you info on how they do this.
Electronics Forum | Thu May 26 06:48:34 EDT 2005 | Base
Even worse, you might be running into patents that prohibit you from building the same stuff they are. Might wanna check that first, because I doubt that Fuji or whoever will grant you a license.
Electronics Forum | Fri May 27 08:55:45 EDT 2005 | cyber_wolf
Quick note on Hover Davis, I am not impressed with their Fuji IP feeders at all. They short out and blow IC's up in the MFU's They sell their own feeder set up stand to tell whether or not you have a shorted feeder. What the hell is up with that ?
Electronics Forum | Thu May 26 14:33:45 EDT 2005 | PeteP
CircuitCam offers great support, a superb product and CheckPoint can handle the Bill of Material comparison tasking you asked about. Friendly staff, good training and I do not receive endorsements $$$$. Just a good product.
Electronics Forum | Thu May 26 15:20:13 EDT 2005 | jh0n!
I'm also looking at a CAM system for our NPI process, but want a system that scales up through data collection off the machines, and from our technicians. The Aegis suite of software looked awesome, but not at into a six-figure pricetag.
