Electronics Forum | Mon Nov 14 08:25:45 EST 2005 | pjc
By "Dip Soldering", do you mean like in a solder fountain type machine as is the Electrovert Soldapak ? http://www.speedlinetech.com/electrovert/soldapak.aspx If so, the nozzle sizes are about the most important for best results, not to mention fl
Electronics Forum | Mon Nov 14 02:39:39 EST 2005 | lantech
Hello all! Our test adapter have not a plate, which close test probes. We want to do a plate with through holes for test probes and holes for guiding and centring pins. We want to order a making this one. Adapter is MTS180. Thanks.
Electronics Forum | Thu Nov 17 13:51:27 EST 2005 | mnguyen
Never could get that thing to work rite. Better off getting a glue stencil or a manual dispenser. Even if you do get it to work it is difficult to control the glue dot size to stay stable either you get too much or not enough.
Electronics Forum | Fri Nov 18 07:16:52 EST 2005 | avalancher
You may want to contact MYDATA on that issue. It may be something wrong with your software version. Perhaps they hvae already fixed this problem.
Electronics Forum | Mon Nov 14 10:45:05 EST 2005 | kmeline
We seem to be having a lot of issues with solder not flowing to the end of surface pads especially on fine pitch. These are assemblies we have run in the past with few issues. The bareboard finishes do not look the best. Has anyone been experiencing
Electronics Forum | Mon Nov 14 14:59:32 EST 2005 | davef
Additional questions are: * Does the problem appear with pasted/soldered only boards, in addition to those with components? * What is the size of the unsoldered area? What is the size of the pad? * Where is the solder mask, relative to the pad? * Wha
Electronics Forum | Mon Nov 14 11:34:44 EST 2005 | jdumont
Has anyone bought the entire assembly library? I was considering it for this years budget. I am afraid of getting outdated material however. Looking for any insight...
Electronics Forum | Mon Nov 14 12:17:17 EST 2005 | avalancher
You should contact MYDATA service department and see what advise their phone support people can offer. You may not be doing the process correctly (wrong calibration boards, etc...)
Electronics Forum | Tue Nov 15 08:17:05 EST 2005 | cyber_wolf
What are you trying to calibrate? I think you mis-typed...there is no W-wagon. I think you meant X-wagon camera. I have never seen one of these go out of cal. Why do you think it needs calibrated ?
Electronics Forum | Tue Nov 15 11:21:32 EST 2005 | davef
Which is it: * Wire bonds don't stick when bonded * Wire bonds fall off, or break during service