Electronics Forum | Fri Dec 14 03:49:19 EST 2007 | cobrasv
Friends, Need some help here. Can anyone gimme any info about single line model RLC parameters of an RJ45 connector.
Electronics Forum | Fri Dec 14 13:39:31 EST 2007 | adlsmt
We are trying to find an ESD safe laminate to make ID badges that we can scan bar codes through. Anyone using anything like that? Thanks!
Electronics Forum | Thu Dec 20 22:13:55 EST 2007 | davef
We have never seen an ID badge that was not a static generator. We certainly wouldn't want to see a typical ID badge within a couple feet of a circuit board. How would you use these ESD-safe badges?
Electronics Forum | Wed Dec 26 21:03:46 EST 2007 | davef
Paulo: And your supposed benefit that I receive is what? What basis do you have to call me a liar?
Electronics Forum | Sun Jan 06 22:48:42 EST 2008 | mac88
Hi, Just put the ID Badge on a EDS-Safe carrier. From "All-Spec" catalog: #1196-3722 - Personnel Badge Holder Clear Dissipative 3.75"x2.25" 6mil with Clip
Electronics Forum | Sun Dec 16 18:11:35 EST 2007 | mdang
Does anyone know what the default administrator password for the Photon Dynamics SV-6000 system? Thank you, -Michael
Electronics Forum | Mon Dec 17 01:14:35 EST 2007 | rfematt
If an oven is marked with a maximum temperature of 300 degrees C, can it be used for LF? Thanks for your help.
Electronics Forum | Mon Dec 17 10:46:04 EST 2007 | realchunks
First of all, more info is needed. Solder shorts can be caused by much more than flux. Is the solder short always in the same spot or all over the place? More detail please.
Electronics Forum | Mon Dec 17 14:16:44 EST 2007 | realchunks
This is funny. Poeple giving answers to a question that isn't specific. What if the shorts he is having are on the top of his board, caused by flooding or Omega wave too high?
Electronics Forum | Mon Dec 17 07:23:23 EST 2007 | janz
Hello Andy, Please try to visit http://www.mechatronika.com.pl. They are manufacturing flexible solution for very small batches. Regards janz